Owner's manual

18
TOLL FREE HELP LINE 1 855 691 5969
MODEL Y4007
MINI CULTIVATOR AND DETHATHER
TROUBLE SHOOTING
Here at Garden Trax,we strive to build the most durable and best quality designed products. However, all the hard work
and best designs and all the careful maintenance on your part will never assure you that there will never be a problem.
Even the small repair can be annoying. So we have prepared a troubleshooting guide to help you through most of these
easil
y fixed r
epairs. The following guide will help you pinpoint the causes of common problems and identify remedies.
For more complicated repairs or any questions you might have concerning your
Garden Trax
unit, please feel free to
contact your place of purchase or The Garden Trax warranty and authorized service center. We will always be glad to
answer any questions you have,
or help you find suitable assistance. To order parts or inquire about warranty, call, write or
email us at the address found below, under the section ordering repair parts.
PROBLEM POSSIBLE CAUSE REMEDY/ACTION
Engine will not start 1. Power switch off 1. Flip switch to ON position
2. Spark plug wire disconnected 2. Connect spark plug wire to spark plug
3. Out of fuel 3. Refuel
4. Spark plug wet, faulty or improperly
gapped
4. Clean, replace or gap spark plug
5. Throttle control not held open
5. Hold throttle control open when pulling recoil
handle
6. Fuel line hose not positioned in
bottom of gas tank
6. Push fuel line down into fuel in gas tank
Engine runs rough, floods during
operation
1. Dirty air filter 1. Clean or replace air filter
2. Choke partially engaged 2. Turn off choke
3. Carburetor out of adjustment 3. Call factory
Engine is hard to start 1. Stale fuel
1. Drain old fuel and replace with fresh.
2. Spark plug wire loose 2. Make sure spark wire is securely attached to
spark plug
3. Dirty carburetor 3. Clean carburetor, use gas stabilizer,
Refuel with fresh gasoline.”
4. Throttle control not held open
4. Prime unit 3 more times, then hold throttle open
when pulling recoil handle
Engine misses or lacks power 1. Clogged gas tank 1. Remove and clean gas tank
2. Clogged air filter 2. Clean or replace air filter
3. Carburetor out of adjustment or bad 3. Call factory
4. Spark plug wet, faulty or improperly
gapped
4. Clean, replace or gap spark plug
Engine runs, then quits 1. Gas cap not venting 1. Clean or replace gas cap, check vent
2. Plugged fuel filter 2. Clean or replace fuel filter
3. Carburetor out of adjustment or bad 3. Call factory
Engine revs too high 1. Carburetor out of adjustment 1. Call factory
Tines turn at idle 1. Idle speed too high 1. Adjust idle speed lower
2. Broken clutch spring 2. Replace spring