Manual

ManualsBrandsGardman ManualsAccessories for waterSandstone Springs

19047 Sandstone Springs Outdoor Water Feature

www.gardman.co.uk

Water Feature place of purchase (Retailer):

Date of Purchase:

Purchase Price:

Please read the assembly instructions and separate pump instructions carefully prior to installation.

Assembly Instructions

 Unpack all the water feature components from the packaging and lie on a flat surface.

 Remove the top part (1) of the feature and connect the rubber tube (2) in to the opening on the pump

(3). Now locate the rubber tube in to the opening located on the underside of the top part of the feature.

Lay the pump inside on the base of the feature (4). Make sure the tube is properly connected and is not

kinked.

 The pump flow can be adjusted by moving the dial (5) which is located on the inlet of the pump.

 Connect the two cables (6) & (7) and screw over the plastic collar (8) until secure.

 The cable is located through the side of the water feature. Plug the 2 pin connector (9) in to the

plug/transformer (10) and tighten the screw collar (11). Do not insert the plug in to the mains at this

time.

 Fill the reservoir with water to 6cm (2 ¼”) from the top of the water feature.

 Set the top part of the water feature onto the base so it sits level.

 Insert the plug/transformer in to the power socket and switch on. If installed correctly water will start to

flow from the feature. Please note: On first use, there may be air in the pump and it may take a few

moments for the water to come through.

Summary of content (4 pages)

PAGE 1
9047 Sandstone Springs Outdoor Water Feature Please read the assembly instructions and separate pump instructions carefully prior to installation. Assembly Instructions  Unpack all the water feature components from the packaging and lie on a flat surface.  Remove the top part (1) of the feature and connect the rubber tube (2) in to the opening on the pump (3). Now locate the rubber tube in to the opening located on the underside of the top part of the feature.
PAGE 2
19047 Sandstone Springs Outdoor Water Feature Care & Cleaning  Ensure the water feature is filled with sufficient water so the pump is well submersed.  Regularly top up the water inside the feature.  To keep your feature free of algae and mould we recommend you use Gardman’s Crystal Clear sachets that are available from your Gardman water feature stockist.  Throughout the winter months you should drain and clear your feature of water so ice does not form.
PAGE 3
19047 Sandstone Springs Outdoor Water Feature Important safety instructions Always unplug the appliance from the electrical outlet after using and before cleaning. Do not drop or place the feature in water or other liquids. Do not connect to any voltage other than that shown on the plug/transformer. Never connect the pump directly in to a mains supply without the use of the step down plug/transformer. Never cover the water feature when it is in operation.
PAGE 4
19047 Sandstone Springs Outdoor Water Feature PROOF OF PURCHASE In the event of your water feature requiring spare parts or servicing you will need to submit the completed form below along with your proof of purchase. Date of Purchase: Place of Purchase (Retailer): Purchase Price: Enclose Your Purchase Receipt Here: Retailer Address: Customer Information Thank you for your purchase of this Gardman water feature. The water feature is guaranteed for one year.