Operation Manual
Table Of Contents
- GPSMAP 172/172C
- Introduction
- Getting Started
- Keypad Usage
- Selecting Options
- Entering Data
- Initializing the Receiver
- Power On/Screen Backlighting
- Simulator Mode
- Main Pages/Map Page
- Map Cursor
- Marking Waypoints
- Using the NAV Key
- Simulated Tour
- Reviewing/CreatingMap Waypoints
- Compass Navigation Page
- Highway Page
- Active Route Page/Main Menu Page
- Deleting Waypoints/Powering Off Unit
- Reference
- Map Page
- Map Page: Cursor
- Map Page: Options
- Compass Page
- Highway Page
- Highway Page Options
- Creating Waypoints
- Reviewing/Editing Waypoints
- Waypoint Lists
- Going to a Destination
- TracBack Navigation
- MOB: Man OverBoard
- Creating Routes
- Creating a Route/Following a Route
- Route List Page
- Route Review Page
- Editing Routes
- Active Route Page
- Find Key
- Find Options
- Main Menu Tabs
- Main Menu:GPS Tab
- Main Menu:Tide Tab
- Main Menu: Trip/
- Main Menu: Track Tab
- Main Menu: DSC Tab
- Main Menu: DSC/Card Tabs
- Main Menu: Temp Tab/Setup Tab
- Main Menu: Comm Tab
- Main Menu: Alarm Tab
- Appendix
- Index
• ELEVATION – Elevation above/below MSL (Mean Sea Level)
• ETA AT DESTINATION – Estimated Time of Arrival to final waypoint
• ETA AT NEXT – Estimated Time of Arrival to next waypoint
• GPS ACCURACY – Shows estimated GPS accuracy
• HIGHWAY – Smaller version of the Highway Page
• MAXIMUM SPEED – Fastest speed the unit has traveled
• MOVE AVERAGE SPEED – Average moving speed
• MOVE TRIP TIME – Time unit has been moving for a trip
• OFF COURSE – Distance from desired track
• POINTER – Arrow points to your destination
• POSITION – Current position coordinates
• SONAR* – Compressed view of sonar data
• SPEED – Speed over ground
• TIME OF DAY – Current time
• TIME TO DESTINATION – Time to final waypoint
• TIME TO NEXT – Time to next waypoint
• TO COURSE – Bearing to desired track
• TOTAL AVERAGE SPEED – Total average speed
• TOTAL TRIP TIME – Total travel time of trip, stopped and moving
• TRACK – Current compass direction of travel
• TRIP ODOMETER – Trip Odometer
• TURN – Directional amount of turn needed to match bearing
• VELOCITY MADE GOOD – Velocity Made Good to destination
• VOLTAGE – Current voltage reading being received by unit
• WATER SPEED* – Speed through the water
• WATER TEMP. LOG* – Timeline graph of the transducer’s temperature reading.
• WATER TEMPERATURE * – Water temperature
*If receiving proper sonar data from other device, such as a GSD 20 Sounder Module or NMEA device.
NOTE: COMPASS, HIGHWAY, POSITION, SONAR, and WATER TEMP. LOG are only available on Large and Huge
sized data fields.
• Turn Declutter On/Off — toggles between showing spot soundings and map outlines for easier
viewing.
Choose the type of data
you wish to display.
Map Setup
Menu Options
26
Reference
Map Page Options