Operation Manual
Table Of Contents
- GPSMAP 172/172C
- Introduction
- Getting Started
- Keypad Usage
- Selecting Options
- Entering Data
- Initializing the Receiver
- Power On/Screen Backlighting
- Simulator Mode
- Main Pages/Map Page
- Map Cursor
- Marking Waypoints
- Using the NAV Key
- Simulated Tour
- Reviewing/CreatingMap Waypoints
- Compass Navigation Page
- Highway Page
- Active Route Page/Main Menu Page
- Deleting Waypoints/Powering Off Unit
- Reference
- Map Page
- Map Page: Cursor
- Map Page: Options
- Compass Page
- Highway Page
- Highway Page Options
- Creating Waypoints
- Reviewing/Editing Waypoints
- Waypoint Lists
- Going to a Destination
- TracBack Navigation
- MOB: Man OverBoard
- Creating Routes
- Creating a Route/Following a Route
- Route List Page
- Route Review Page
- Editing Routes
- Active Route Page
- Find Key
- Find Options
- Main Menu Tabs
- Main Menu:GPS Tab
- Main Menu:Tide Tab
- Main Menu: Trip/
- Main Menu: Track Tab
- Main Menu: DSC Tab
- Main Menu: DSC/Card Tabs
- Main Menu: Temp Tab/Setup Tab
- Main Menu: Comm Tab
- Main Menu: Alarm Tab
- Appendix
- Index
FCC Compliance
The GPSMAP 172/172C complies with Part 15 of the FCC interference limits for Class B digital devices
FOR HOME OR OFFICE USE. These limits are designed to provide more reasonable protection against
harmful interference in a residential installation, and are more stringent than “outdoor” requirements.
Operation of this device is subject to the following conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
The GPS 172/172C does not contain any user-serviceable parts. Repairs should only be made by an
authorized Garmin service center. Unauthorized repairs or modifications could result in permanent
damage to the equipment, and void your warranty and your authority to operate this device under Part
15 regulations.
ii
Introduction
FCC Compliance