Operation Manual
Table Of Contents
- GPSMAP 172/172C
- Introduction
- Getting Started
- Keypad Usage
- Selecting Options
- Entering Data
- Initializing the Receiver
- Power On/Screen Backlighting
- Simulator Mode
- Main Pages/Map Page
- Map Cursor
- Marking Waypoints
- Using the NAV Key
- Simulated Tour
- Reviewing/CreatingMap Waypoints
- Compass Navigation Page
- Highway Page
- Active Route Page/Main Menu Page
- Deleting Waypoints/Powering Off Unit
- Reference
- Map Page
- Map Page: Cursor
- Map Page: Options
- Compass Page
- Highway Page
- Highway Page Options
- Creating Waypoints
- Reviewing/Editing Waypoints
- Waypoint Lists
- Going to a Destination
- TracBack Navigation
- MOB: Man OverBoard
- Creating Routes
- Creating a Route/Following a Route
- Route List Page
- Route Review Page
- Editing Routes
- Active Route Page
- Find Key
- Find Options
- Main Menu Tabs
- Main Menu:GPS Tab
- Main Menu:Tide Tab
- Main Menu: Trip/
- Main Menu: Track Tab
- Main Menu: DSC Tab
- Main Menu: DSC/Card Tabs
- Main Menu: Temp Tab/Setup Tab
- Main Menu: Comm Tab
- Main Menu: Alarm Tab
- Appendix
- Index
• Edit on Map — review and modify the route displayed for each point (waypoint or map item)
on a map page. You may also use the cursor to insert a new route point on a route leg, review the
waypoint or map item.
To edit a route on the map:
1. From the Route Review page, press MENU, highlight ‘Edit on Map’ and press ENTER.
To review a route point:
1. Highlight the point and press ENTER. The Review page appears. Highlight ‘Next’ and press ENTER
to return to the map with the next route point highlighted.
To edit a route point:
1. Use the ARROW KEYPAD to highlight the desired route waypoint and press MENU.
A pop-up menu of editing choices appears, with the following options: Edit as Text (return to the
Route Review page), Remove, Move (user waypoints only), and Add.
To remove a route waypoint:
1. Highlight the ‘Remove’ option and press ENTER.
To move a route waypoint:
1. Highlight the ‘Move’ option and press ENTER.
2. Move the cursor to the new map position and press
ENTER.
To add points to the beginning or end of the route:
1. With the map cursor, select the first route waypoint (to add waypoints to the beginning of the
route) or last (to add waypoints to the end of the route) and press
MENU.
2. Highlight the ‘Add’ option and press
ENTER.
3. Move the cursor to the new point or position and press
ENTER.
4. If you are not adding an existing waypoint, press
ENTER to confirm the new waypoint.
5. Repeat steps 3 and 4 to add additional waypoints or press
QUIT to finish.
Highlight a route point and
press
ENTER to review it.
Choose ‘Next’ to center the map on the next
point in the route. You can step through the
points by repeatedly pressing
ENTER.
47
Reference
Editing Routes