Operation Manual
Table Of Contents
- GPSMAP 172/172C
- Introduction
- Getting Started
- Keypad Usage
- Selecting Options
- Entering Data
- Initializing the Receiver
- Power On/Screen Backlighting
- Simulator Mode
- Main Pages/Map Page
- Map Cursor
- Marking Waypoints
- Using the NAV Key
- Simulated Tour
- Reviewing/CreatingMap Waypoints
- Compass Navigation Page
- Highway Page
- Active Route Page/Main Menu Page
- Deleting Waypoints/Powering Off Unit
- Reference
- Map Page
- Map Page: Cursor
- Map Page: Options
- Compass Page
- Highway Page
- Highway Page Options
- Creating Waypoints
- Reviewing/Editing Waypoints
- Waypoint Lists
- Going to a Destination
- TracBack Navigation
- MOB: Man OverBoard
- Creating Routes
- Creating a Route/Following a Route
- Route List Page
- Route Review Page
- Editing Routes
- Active Route Page
- Find Key
- Find Options
- Main Menu Tabs
- Main Menu:GPS Tab
- Main Menu:Tide Tab
- Main Menu: Trip/
- Main Menu: Track Tab
- Main Menu: DSC Tab
- Main Menu: DSC/Card Tabs
- Main Menu: Temp Tab/Setup Tab
- Main Menu: Comm Tab
- Main Menu: Alarm Tab
- Appendix
- Index
Main Menu: DSC Tab
There are two ways to add a new entry into the directory.
To add a new Directory entry:
1. Press Menu, then highlight ‘New Item’ and press ENTER.
2. Or, with the Directory Tab highlighted press the Arrow Keypad DOWN, highlight an empty field and
press ENTER to access the New Directory Item window.
The New Directory Item window allows you to input information of a known contact.
To add the MMSI number, Name, or Comment:
1. Press UP/DOWN on the Arrow Keypad to highlight the MMSI, Name, or Comment field.
2. Press
ENTER to highlight the first digit on that field.
3. Press UP/DOWN on the Arrow Keypad to enter the numbers/letters.
4. Press
LEFT/RIGHT on the Arrow Keypad to move to the next position.
5. Press
ENTER to accept the entry.
6. Press UP/DOWN on the Arrow Keypad, highlight the ‘Delete’ button and press
ENTER to delete
the entry, or highlight the ‘OK’ button and press
ENTER to accept the entry.
After creating a New Directory Item entry, the name created is attached to that particular MMSI
number. If you return to the Log, the new name is displayed under the corresponding MMSI number.
Another way to input a name is from the Entry Review page or the DSC Distress Call or DSC Posi-
tion Report pages. The Name field is only available in the GPS. Names cannot be sent like the MMSI
numbers to other DSC users.
DSC Setup
Garmin chartplotters have the ability to turn DSC ‘On’ or ‘Off’. This option is beneficial for users
who have more than one GPS chartplotter. If you want only DSC to display on a particular chartplotter,
turn DSC off on the remaining Garmin chartplotters that support DSC.
Adding a Directory Entry
DSC Setup
“Simulate..” options only appear while in
Simulator mode..
67
Reference