Design Juicer Pro User Manual

Step 1:
Place the filter bowl surround on the motor
block (picture 1).
Step 2:
WARNING: Handle the parts with care
and do not use any force. Pay attention
to the sharp blades on the stainless steel
micro mesh filter and the feed chute to
avoid injury. Always completely assemble
your juicer before you plug the plug into
the power outlet.
ATTENTION: Ensure the stainless steel fil-
ter basket is clean before assembling. Any
dehumidified left over food on the basket
will block the fine mesh holes. If necessary
remove excess fibre build up (from fruit or
vegetables) according to the instructions
›Care and Cleaning‹.
Align the arrows on the stainless steel filter
basket with the arrows on the motor drive
coupling and push down until it clicks into
place. Ensure the stainless steel filter basket
is fitted securely inside the integrated pulp
container and onto the motor base (picture 2).
Step 3:
Place the juicer cover over the stainless
steel filter on top of the filter bowl surround
(picture 3). The feed chute has to be posi-
tioned in the middle of the filter basket and
the pulp spouting of the cover has to face
away from the interlocking safety arm.
ASSEMBLING YOUR DESIGN JUICER
1
2
3
2
OPERATING
40 41