Design Food Processor User Manual

ATTENTION: Never hold your face or other body parts over the feed chute when the

motor is running because little pieces of food could be thrown out of the feed chute.

WARNING: Do not overfill the container. Possibly, take some food out of the container,

using a wooden or plastic spoon, before starting the appliance again.

11. Turn the appliance off and pull the plug when the appliance is not in use and you

finished the operation.

12. Empty the bowl. Clean the appliance in accordance to the instructions in chapter

‘Care and Cleaning`. Do not leave any food dry on the surfaces of the appliance.

Making French Fries

WARNING: Always turn the appliance ´OFF`, wait until the motor stops and unplug the

appliance before assembling/disassembling. Always completely assemble your appliance before

you plug the plug into the power point. Only touch the discs and blades on the edge and

handle with care when cleaning.

1. Place the container on a suitable, stable, dry, and clean working surface. (see:

‘Safeguards for Daily Operation’).

2. Place the bowl on the motorblock turning it anticlockwise until it is securely locked in position.

Do not use any force. The handle should be facing the front which is above the control panel.

3. Place the disc stem on the drive shaft in the middle of the bowl

(picture A). The long shaft of the disc stem has to slide over the

drive shaft and the end with the aglet should face upright. If necessary

turn the disc stem a little to fit in position. The disc stem sticks out

of the bowl for 1 or 2 cm.

4. Put the slicing disc for french fries on top of the disc stem turn-

ing the disc until the hexagonal nut of the disc fits on the hexagon bolt

of the disc stem. (picture B). IMPORTANT: The side of the disc

with the blade has to be up.

5. Attach the lid to the bowl (picture C). The feed chute can be

facing either ways: the front with the control panel or the opposite

side. Turn the lid anticlockwise until it is securely locked and in position.

IMPORTANT: The humps of the rim of the lid should align with

the small plastic wings on the bowl. Lower into position. The lid has

to be securely locked.

NOTE: The appliance will not turn ‘ON` unless properly assembled.

6. Prepare your food and fill it in the container. If necessary cut

the food in proper size to fit through the feed chute (see ´Tips for

preparing the food`).

40962_foodprocessor_manual_mai07.qxp 18.07.2007 10:38 Seite 33