User Manual

ATTENTION: Never place the holder or the blade only on the motorblock. Never touch

the drive gear when the plug is connected to the power outlet. Never combine the con-

tainer and the holder without the blade. Without the blade the bottom of the con-

tainer is open. Spilled liquids might run right into the motor.

ATTENTION: When liquids are spilled on the motor housing, immediately unplug

the appliance and dry the motor housing to avoid risk of electric shock or fire. Do

not attempt to operate the appliance, when liquids are on or in the motor housing.

ATTENTION: Never try to sharpen the blade. Replace the blade if it is blunt. Please

contact our service department for the replacement part.

4. Place the proper assembled container onto the motorblock. Turn the container until

it locks onto the motorblock. Load the container with ingredients, pick a speed on the

control panel and start processing.

ATTENTION: Always ensure the motorblock is turned off when placing the container on

the motorblock to avoid personal injury.

Assembling & disassembling the 300 ml glass container

Clean the glass container before you connect the holder and the

blade. Unscrew the lid of the glass container turning it clockwise.

Remove the lid and the sealing ring of the lid and fill the container

with ingredients you want to process.

IMPORTANT: Do not overload the container. The container is for

processing small portions only. NOTE: The container is

hermetically sealed with the lid and ideal for storing food.

1. The blade has a sealing ring which has to abut exactly

around the edges (see picture A). Ensure the sealing ring is

sealing properly. The sealing ring has to be clean and show no

crustifications, crinkles, cracks or look porous.

2. Place the sealing ring of the blade on top of the glass container.

The blade is inside the container. The edge of the sealing ring

should be flush with the edge of the glass container (see picture B).

3. Place the holder on top of the sealing ring. The screw-thread

of the holder should face downward (see picture C).

Hold on to the holder with your left hand and with your right hand

hold on to the handle of the container. Screw the container

anticlockwise onto the holder. Both parts should be properly

connected to seal the container (see picture D). Otherwise

ingredients will get into the motorblock and might damage it.

40993_mixmax_manual.qxp 20.12.2006 11:11 Seite 27