Operating instructions

After approximately 1½ minutes of frothing, or when Frothing Pitcher

begins to feel warm to touch, press down on Flavor Hatch so that it

opens fully and pouring channel is exposed. Pour desired amount of

flavoring into Pitcher. Push back end of Flavor Hatch forward and down

to close.

Note: As a safety feature, the Milk Frother cannot be restarted immedi-

ately after reaching its shut off temperature. Either pour cold water into

Pitcher or wait a few minutes until unit has reached a safe temperature.

If you prepare more froth than you require and the remaining froth in

the Pitcher has lost some of its richness, or the froth temperature has

declined, you may refresh the froth to its original richness and

temperature by simply pressing the ON switch.

7. Allow about 30 - 60 seconds for the hot milk to settle. Then, unplug

the power cord, and using the spout, carefully pour the desired amount

of hot milk for Cappuccinos, Lattes or other specialty drinks.

Remember that liquid milk heats to a higher temperature than froth. When

serving to children, wait until the hot milk cools slightly or stop unit early by

pressing the OFF switch.

8. Remove Lid from Frothing Pitcher, place Lid upside down on the counter to minimize any

milk spillage, and spoon out the rich froth.

Note: After use, clean your appliance following the ´Care and Cleaning´ instructions.

Between consecutive cycles, the unit must be rinsed with COLD water. To help cool Pitcher,

allow cold water to remain in Pitcher for a few minutes.

After 4 consecutive cycles, unit must be shut off for approximately 10 minutes.

Caution: Only liquids or powdered mixes can be used. Solid food items must not be used

while unit is operating as they may cause damage to the Froth Whip.

Care and Cleaning

Before first use and after each use, it is important that you clean your Milk Frother following

the guidelines below. You should rinse Pitcher in cold water between consecutive cycles.

• ALWAYS UNPLUG POWER CORD FROM UNIT PRIOR TO CLEANING AND

NEVER IMMERSE IN WATER.

• To allow Froth Whip to be thoroughly cleaned, remove Lid from Frothing Pitcher and

hold Lid with Whip facing upward. Remove Whip and Whip Holder by firmly grasping

Whip Holder and pulling outward and away from Lid. You may also remove Whip from

Whip Holder by securely grasping Whip Holder with your thumb and pointer finger and

turning Whip counterclockwise one quarter turn.