Owner manual

CARE & CLEANING INSTRUCTIONS
After each use it is important that you properly clean your new Froth Au Lait
appliance. You should rinse the pitcher in cold water prior to using. In addition, the
following guidelines should be adhered to:
Immediately after each use, place a small amount of warm water in the
Frothing Pitcher to soak. The water helps prevent the buildup and drying of
milk and flavored powders on the non-stick surface and makes cleaning
easier.
The Frothing Pitcher, Froth Whip, lid, and Flavor Hatch™ should be carefully
washed with warm soapy water using
. Then rinse and dry with a soft towel.
Care
.
Between consecutive frothing cycles and prior to use, the appliance should
be rinsed with water to ensure proper operation.
: Always rinse with water and dry prior to frothing milk.
CARE OF THE BASE UNIT
ALWAYS1
1
1
1
1
1
1
1
unplug the base unit prior to cleaning and
. Wipe the unit with a warm damp cloth and then dry.
The Frothing Pitcher should never be placed in an automatic dishwasher!
never immerse it in
water
CARE OF THE FROTHING PITCHER & FROTH WHIP ASSEMBLY
1
cold
Remember cold
a sponge or scrubber pad designed for
Teflon or non-stick surfaces
should be taken when cleaning and drying the bottom plate of the
Frothing Pitcher so that the non-stick surface is not damaged
Occasionally, it is recommended that the Froth Au Lait appliance be
operated with 1 cups of water and a small amount of mild detergent.
Care should be taken when cleaning smaller parts, such as the Flavor Hatch,
to avoid dropping in the garbage disposal or accidentally discarding in the
trash.
NEVER USE ABRASIVE CLEANERS, METAL SCOURING PADS, OR
CLEANING PADS NOT APPROVED FOR NON-STICK SURFACES.
AVOID USING CLEANING UTENSILS WITH HARD SURFACES SUCH
AS PLASTIC OR METAL.
½
-3-
WARNING: RISK OF FIRE OR
ELECTRICAL SHOCK. DO NOT OPEN.
The lightning symbol refers to “dangerous voltage;” the exclamation symbol refers
to maintenance instructions. See below.
To reduce the risk of fire or electrical shock, do not remove the bottom
cover from the base unit or disassemble the container heating unit. Repair should be
done by authorized service personnel only.
WARNING:
This appliance has a polarized plug (one blade is wider than the other). To reduce
the risk of electric shock, this plug is intended to fit into a polarized outlet only one
way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician. Do not attempt to modify the plug in any way.