Design Espresso Machine Advanced Pro G Owner's manual

STEP 10 – EMPTYING THE PORTAFILTER

• Remove the portafilter from the group head by rotating the portafilter to the left until it

releases.

• To empty the used grounds, turn the portafilter upside down in a bin and gently knock out

the grounds. Used grounds should be thrown away with domestic waste. Discarding of used

grounds in a sink can cause drains to become blocked.

• With the filter still in place, hold the portafilter underneath the group head, press and hold

down the one cup button to release hot water. Rinse the portafilter until water runs clear.

• Insert the portafilter back into the group head to dry out and keep warm.

WARNING: THE METAL PARTS OF THE PORTAFILTER WILL BE VERY HOT.

THE ART OF TEXTURING MILK

The appliance comes complete with a commercial style swivel steam

wand and stainless steel frothing attachment. When using the frothing

attachment on the steam wand a large amount of froth is easily created.

If less froth is desired, remove the frothing attachment from the steam

wand before texturing. To remove the frothing attachment, ensure it is

cool then simply pull down and remove. The frothing attachment can

be stored in the storage tray located behind the drip tray, if not used

regularly. To refit the frothing attachment ensure it is securely attached to the steam wand

by inserting it, from either end, onto the steam wand and pushing firmly upwards onto the

rubber surround.

• Fill the stainless steel frothing jug maximum ½ full with cold, fresh milk.

• Turn the steam selector dial to the Steam-position. The red steam light

will start to flash indicating that the machine is heating to create steam.

• When the steam light stops flashing it is ready to use.

• Before inserting the wand into the milk, pause the steam by returning

the dial back to the STAND BY-position. This will avoid splashing the

milk out of the jug (this pause function lasts for 6 seconds before exiting

steam mode).

• Insert the wand into the milk and return the Steam dial back to Steam-position.

• To stop, return the steam dial to the STAND BY-position and remove the jug.

Note: When the espresso machine creates steam, a pumping noise can be heard. This is

the normal operation of the 15 Bar pump.

Note: After 5 minutes of continuous steaming, the machine will automatically disable the

steam function. The steam light will flash. When this occurs return the steam dial to the

STAND BY-position.

WARNING: Milk should not be allowed torun over the top of the frothing attachment,

otherwise it will not function properly. To avoid splattering of hot milk, do not lift the end of

the frothing attachment above the surface of the milk while frothing. Ensure the steam selec-

tor dia is in the STAND BY-position before removing the frothing jug.