Operating Guide

GasWatch BBQ Tank Level Indicator

Digital Scale - Operation Guide

(Model - TVL216)

_____________________________________________________________________

Function Buttons

ON/OFF

Use this button to turn the scale on or off.

RESET

This option allows you to select the weight of your tank. Please see steps 3 through 6 (located under First

Time Use) for additional information on how to use the RESET button.

First Time Use

1. Remove the GasWatch™ Digital Tank Scale from the box.

2. Insert 2AA batteries into the digital display.

3. Press the ON/OFF button to turn on the scale. “0%” should appear on the display.

4. Place the tank on the scale

 Do NOT shut the display off prior to putting the tank on the scale.

 The tank must be placed on the scale prior to setting the weight.

5. Press the RESET button until you see the weight of your tank appear.

 The weight is located on the collar of the tank.

6. When you see the weight of your tank appear stop pressing the RESET button.

 The weight will automatically set to the last number that appeared.

 Available Weight Selections: 16.6lb, 17.2lb, 17.6lb, 18.0lb, and 19.0lb. The default

weight is 17.6 pounds

Check Propane Level

1. Press the ON/OFF button to power up the scale.

2. If the scale detects that the tank is full it will display 100%.

3. If the scale detects that the propane tank is not full (but contains some propane) the estimated

cook time remaining will still be accurate as long as the weight listed on the collar of the tank was

programmed accurately.

4. The display beeps at a tank weight of 10% and below. When the tank weight reaches 10% it will

beep for 5 seconds and then shut off.

5. The LCD will alternate between the percentage of gas remaining and the remaining cook time in

minutes by pressing the reset button.

ERROR Messages

LO: Low battery

ERR: Load over of 43lb has been detected.

00: No tank is on the scale or the weight programmed into the scale is less than the actual weight of your

tank. Please see steps 3 through 6 under First Time Use.

PAGE 1
GasWatch BBQ Tank Level Indicator Digital Scale - Operation Guide (Model - TVL216) _____________________________________________________________________ Function Buttons ON/OFF Use this button to turn the scale on or off. RESET This option allows you to select the weight of your tank. Please see steps 3 through 6 (located under First Time Use) for additional information on how to use the RESET button. First Time Use 1. Remove the GasWatch™ Digital Tank Scale from the box. 2.
PAGE 2
Helpful Hints  Make sure the tank is seated properly within the GasWatch™ scale ring.  Do not shut the display off prior to setting the propane tank on it.  The propane tank must be on the scale in order to program the weight.  Display will automatically turn off after 30 sec.  If the display is not working:  o Press the ON/OFF button o Check the batteries to make sure that they are in good condition and functioning properly.