Conventional Flue Instructions

11
User Instructions
7.23 Place Log A across Log C. There is a hole on the underside
of Log A which fits over the raised stud on Log C to secure
in place. The small cut out on the left side of the log rests
onto the log guard, see Diagram 28.
28
7.24 Sparingly spread an amount of the Embaglow bres
provided, covering the ports in the burner tray, Diagram 29.
Take care not to use more than half a packet per
application.
WARNING - DO NOT PLACE NEAR THE PILOT AREA.
IT IS ESSENTIAL TO KEEP THE REAR PORT FREE
FROM OBSTRUCTION.
29
Keep Rear
Port free from
Embaglow
7.25 Once the fuel bed arrangement is complete, replace the
glass frame and secure, see User Section 5.
8. Flame Failure Device
8.1 This is a safety feature incorporated on this appliance which
automatically switches off the gas supply if the pilot goes out
and fails to heat the thermocouple.
IF THIS OCCURS DO NOT ATTEMPT TO RELIGHT THE
APPLIANCE FOR 3 MINUTES.
9. Running In
9.1 During initial use of a new Gazco appliance a strong odour
will be encountered as various surface coatings become hot
for the first time. Although these odours are harmless it is
recommended that the appliance is operated on maximum
for 4 to 8 hours in order to fully burn off these coatings. After
this period the odours should then disappear.
If the odours persists, please contact your installer for
advice.
9.2 During the first few hours of burning there may be
discolouration of the flames. This will also disappear after a
short period of use.
10. Servicing
10.1 The appliance must be serviced every 12 months by a
qualified Gas Engineer. In all correspondence always quote
the Model number and the Serial number which may be
found on the Commissioning Checklist (Page 3).
11. Ventilation
11.1 Any purpose provided ventilation should be checked
periodically to ensure that it is free from obstruction.
12. Installation Details
12.1 Your installer should have completed the commissioning
sheet at the front of this book. This records the essential
installation details of the appliance. In all correspondence
always quote the Model number and Serial number.
13. Hot Surfaces
13.1 Parts of this appliance become hot during normal use.
13.2 Provide a suitable fire guard to protect young children
and the infirm.