Conventional Flue Instructions

17
Installation Instructions
3. Installation of the Appliance
IMPORTANT: THE OUTER PANELLING OF THE
VISION IS MADE FROM GLASS. USE CAUTION
WHEN INSTALLING, REMOVING AND STORING AS
THE COMPONENTS ARE FRAGILE AND COULD
BREAK UNLESS HANDLED CAREFULLY.
3.1 Remove the glass plinth to access the controls:
Small
Lift the hooks clear of the slots on the front of the appliance
and lower so that the tab on the glass plinth clears the glass
front, see Diagram 1.
Midi & Medium
Lift the hooks clear of the slots on the front of the appliance,
see Diagram 1.
1
Midi & MediumSmall
All Models
3.2 Remove the frame to gain complete access to the control
valve and the viewing aperture by lifting the hooks clear of
the slots on the front of the appliance, see Diagram 2.
2
Small & Midi only
SECURING THE APPLIANCE
The appliance sits on a mounting bracket to secure it in
place to either the hearth or bench.
3.3 Position the appliance:
Loosely attach the bracket to the appliance and place
centrally on the hearth OR in the desired position on the
bench. Remove the appliance leaving the bracket in the
correct position and mark the holes to drill the bracket
screws, see Diagram 3.
Bracket
3
Small & Midi only
3.4 Remove the bracket and drill the guide holes.
3.5 Fix the bracket either to the hearth or the bench, see
Diagram 3.
NOTE: Use the wood screws and rawl plugs in the fixing
kit supplied for hearth mounting installations and the
self tapping screws for installation onto a bench.
3.6 Lift the appliance so as to locate the key slots in the carcass
onto the fixing screws. There are two large holes the lower
flanges on the front edges of the base, see Diagram 4.
Wingnut
Washer
Key slots
4
3.7 Place the two large washers over the studs and fix with two
wingnuts, see Diagram 4.