Conventional Flue Instructions

18
4. Fitting the Top Plate
4.1 The Vision has a decorative plate that sits on top of the
outer box. Depending on the choice of flue exit this top will
have a hole for the flue pipe to pass through or be
completely smooth.
The hole will be situated in an off set position to the rear
edge of the glass top.
When installing the spigot must be put in place before the
glass top is located. Then the connection to the flue can be
made.
NOTE: For Top Exit appliances the flue collar must be
placed on the flue exit before the top is fitted.
4.2 To fit the top line up the raised fins on the underside of the
glass plate with the cut outs in the top of the box, see
Diagram 5a & 5b.
Rear Exit
Fins
Cut Outs
5a
Top Exit
Cut Outs
Offset edge
to rear
Fins
5b
4.3 When properly fitted the rear of the glass plate should sit
flush with the rear of the appliance, see Diagram 6.
6
Installation Instructions
5. Gas Soundness Pressure Check
5.1 Connect a suitable pressure gauge to the test point located
on the inlet fitting and turn the gas supply on. Light the
appliance and check all gas joints for possible leaks. Turn
the appliance to maximum and check that the supply
pressure is as stated on the databadge. Turn the gas off
and replace the test point screw, turn the gas on and check
the test point for leaks.
7
6. Removing the Glass Frame
6.1 Small and Midi only:
Using screwdriver remove the 6 screws securing the window
panel to the appliance, see Diagram 8, Arrows A.
6.2 Medium only:
Using screwdriver remove the 8 screws, securing the
window panel to the appliance, see Diagram 8, Arrows
A & B.
8
A
A
A
A
A
A
B
B
Take care to support the glass when removing the screws.