Conventional Flue Instructions

21
Installation Instructions
8.11 Place the rear log into position between the rear brackets
and pushed up against the back panel, see Diagram 19.
Log 1
19
8.12 Place the second log into the left hand groove on the burner
tray, see Diagram 20.
The log should butt up against the raised molding and the
left hand side liner.
Log 2
20
8.13 Place the third log into the groove on the right hand side,
see Diagram 21.
The log should butt up against the raised molding and the
right hand side liner.
Log 3
21
8.14 Once the logs are in there are two embers which can be
loosely placed at the front of the fuel bed and cover the tabs
securing the burner tray, see Diagram 22.
Embers
22
8.15 Sparingly spread an amount of the Embaglow bres
provided, covering the ports in the burner tray,
see Diagram 23.
It is essential to cover the port in the middle of the
burner tray in order to get the most visually appealing
flame picture.
Take care not to use more than half a packet per
application.
WARNING - DO NOT PLACE NEAR THE PILOT AREA.
It is essential to
cover the
central port
Embaglow
23
8.16 Fix log guard into position, see Diagram 24.
24