Conventional Flue Instructions

8
7.5 Place the small Ember at the front left of the firebox against
the rear of the log support bracket to obscure the reflection
of the burner screw.
Place the larger Ember on the lower bracket above the pilot
on the right hand side with the thicker edge facing the front
and flat edges to the base and side, see Diagram 10.
10
7.6 Log C rests on the cutout on Log E and is pushed up to the
side and rear of the firebox, see Diagram 11.
11
7.7 Place the pointed bottom of log D into the corner of the
burner tray and rest on the location stud in log B, see
Diagram 12.
12
User Instructions
7.8 Sparingly spread an amount of the Embaglow bres
provided, covering the ports in the burner tray. Use a small
piece in front of the log on the left hand side and a long strip
in front of log B, see Diagram 13.
Take care not to use more than half a packet per
application.
WARNING - DO NOT PLACE NEAR THE PILOT AREA.
Embaglow
13
7.9 Lower log guard into position, see Diagram 14.
14
Midi Vision Layout
7.10 Ensure the burner tray is clean and free from any debris,
see Diagram 15.
15
The three logs that make up the fuel bed are visually distinct
and fit into specific parts on the burner tray.