Installation Guide

STEP 13: PUSH DISHWASHER INTO
FINAL POSITION
• Check the tub insulation blanket, if equipped, to be sure it is
smoothly wrapped around the tub. It should not be “bunched
up” and it must not interfere with the door springs. If the
insulation is “bunched up” or interfering with the springs,
straighten and recenter the blanket prior to sliding the
dishwasher into its final position.
• Slide the dishwasher into the final position by pushing on
the sides of the door panel. Do not push or pull the door
in a partially open or closed position when moving the
dishwasher. Do not use a knee or push on the center of the
panel. If you do, damage to the panel will likely result. Check
that the dishwasher is squarely positioned in the cabinet
opening at both the top and the bottom of the appliance prior
to mounting to the cabinet.
IMPORTANT – Before opening the dishwasher door,
be certain the edges of the dishwasher door panel are behind
WKHIDFHRIWKHDGMDFHQWFDELQHWDQGQRWXSDJDLQVWWKHFDELQHW
face. Refer to Figure U. If the dishwasher door is opened
when the edge of the door is against the face of the cabinet,
dishwasher door damage and cabinet damage will occur.
Figure U
Dishwasher Installation
9
Tip: Prevent unnecessary service charges for panel damage
or wash performance.
Check dishwasher alignment prior to opening dishwasher door
to prevent panel damage.
Make sure utility lines are not trapped or crushed behind
dishwasher. Crushed lines will restrict water flow.
Door Catches
on Cabinet Frame
Correct
Alignment
Incorrect Alignment
will result in door damage
Door
Fits and
Swings
Back
Behind
Cabinet
Frame
• Open and close the dishwasher door to be sure it operates
VPRRWKO\DQGGRHVQRWUXERQWKHDGMDFHQWFDELQHW
Check that tub trim does not
contact the door at all points
Tub trim may be trimmed if
necessary to ensure proper door
operation
Top
View
Handle
Door
Tub trim
Tub frame
Do not allow tub trim to get
trapped by or come into contact
with the door
Top
View
Tub trim
trapped
E\GRRU