Built-In Dishwashers Installation Instructions

15
SET WATER HARDNESS
Models with bulk dispenser only. Skip this step if your
dishwasher does not have the bulk dispense feature.
• Locate the hard water test strip set aside in Step 1.
• Remove strip from package.
• Turn on the hot water and hold the strip under the stream,
following the directions on the package.
• Use the value on the test strip to calibrate your dishwasher
for water hardness. Refer to the section titled "Water
Hardness Calibration" in your Owner's Manual for
information on how to calibrate your dishwasher.
STEP 21
Installation Instructions/Custom Panel Dimensions
DISHWASHER WET TEST
• Turn on power supply (or plug power cord into outlet,
if equipped).
• Start the unit to check for leaks.
– Push RINSE ONLY pad.
– Push START/RESET pad one time.
– Close door.
• Check to be sure that water enters the dishwasher. If water
does not enter the dishwasher, check to be sure that water
and power are turned on.
• Check for leaks under the dishwasher. If a leak is found,
turn power supply off, then tighten connections. Restore
power after leak is corrected.
• Check for leaks around the door. A leak around the door
could be caused by door rubbing or hitting against
adjacent cabinetry. Reposition the dishwasher if
necessary. See Step 13, 14 and 15.
• The dishwasher will drain and turn off about 5 minutes after
it was started. Check drain lines. If leaks are found, turn off
power supply and correct plumbing as necessary. Restore
power after corrections are made. See Step 10 and 17.
• Open dishwasher door and make sure most of the water
has drained. If not, check that disposer plug has been
removed and/or air gap is clear. See Step 17. Also check
drain line to be sure it is not kinked.
• Run the dishwasher through another “Rinse Only” cycle.
Check for leaks and correct if required.
STEP 20
INSTALL SOUND UPGRADE KIT
IF EQUIPPED
Skip this step if your model does not have the Sound
Upgrade Kit.
• Locate sound upgrade kit set aside in Step 1 and the two
screws set aside in Step 6.
• Attach the plastic Sound Panel as shown in Figure II
using the two screws. The lower set of mounting holes
should be used.
• Be sure the sound panel is seated in the notches on frame
as shown in Figure II.
STEP 22
Sound panel is located
under door panel.
Plastic Sound
Panel with Foam
Attachment
Screws
Be sure that the sound panel is seated
in the notch in the frame. (Both sides)
Figure II