Built-In Dishwashers Installation Instructions

INSTALL DRAIN HOSE TO
DISHWASHER DRAIN PORT
In this step you will need the drain hose and clamp set
aside in Step 1.
• Stand the dishwasher upright.
• Place drain hose clamp over 1-3/16" inside diameter
end of drain hose with the clamp screw positioned
on the bottom of the hose.
IMPORTANT— Prevent drain hose damage and
possible leaks. Be careful not to nick or cut the drain hose.
• Push the end of the drain hose over the drain pump
outlet being careful not to disturb the check valve.
Refer to Figure Q.
• Seat the drain hose end against the hose stops on
the pump outlet.
• Position hose clamp against the front lip of the drain
hose and tighten clamp.
NOTE: Drain hose
supplied with
dishwasher is
approximately 78"
long. If a longer hose
is needed, a 120"
long hose (10 feet)
may be purchased
from an authorized
GE appliance dealer.
The 10' long hose is
part number GPF10L.
Tip for leak-free
connections:
• Insert hose against stop on pump.
• Position clamp against front lip of drain hose.
• Tighten clamp to at least 15 inch-pounds of torque.
Tip for quiet drain pump operation:
Position hose clamp with clamp screw on the bottom side
of the hose. This will prevent the clamp from coming in
contact with the rear brace. Clamp contact with the rear
brace could create noise when the drain pump is running.
STEP 10
POSITION WATER LINE AND
HOUSING WIRING
• Position water supply line and house wiring on the floor
of the enclosure to avoid interference with base of
dishwasher and components under dishwasher.
STEP 9
9
Installation Instructions
Figure P
INSTALL POWER CORD
Skip this step if dishwasher will be permanently connected to
the house electrical system.
In this step you will need the junction box cover and the #10 x 1/2"
hex head screw from the screw kit set aside in Step 1.
The power cord and connections must comply with the National
Electrical Code, Section 422 and/or local codes and ordinances.
Maximum power cord length is 6 feet. Power Cord Kit WX09X70910,
available for purchase from an authorized GE Appliance Dealer,
meets these requirements.
• Install strain relief in junction box bracket.
• Insert power cord through strain relief and tighten.
• Make sure black, white and green dishwasher wires are threaded
through small hole in junction box bracket.
• Connect like-colored dishwasher and power cord wires. If power
cord wires are not color coded, connect the ribbed power cord
wire to the white dishwasher wire, the smooth power cord wire
to the black dishwasher wire and the ground to the green
dishwasher wire. Use UL-listed wire nuts of appropriate size.
• Install junction box cover set aside in Step 1, using #10 hex head
screw. Be sure wires are not pinched under the cover.
STEP 7
Figure N
INSTALL 90° ELBOW
• Wrap 90° elbow with thread seal tape.
• Install a 90° elbow onto the water valve.
• Do not overtighten 90° elbow, water valve bracket could bend
or water valve fitting could break.
• Position the end of the elbow to face the rear of the dishwasher .
STEP 8
Figure O
Figure Q
Pump
Outlet
Hose Clamp
Hose Stops
Hose Clamp
Check Valve
Do Not Remove
Front of Dishwasher
Water Valve
Bracket
Water
Line
House
Wiring
5"
5"
4"
4"
6"
Fill Hose
Thread Seal Tape
90˚ Elbow
Ground
Black
White