User Manual

4
PRODUCT DIMENSIONS AND CLEARANCES
TOOLS REQUIRED
• #2, Phillips screwdriver
• Handheld drill
• High-speed drill bit, 1/8” diameter
• 3/8”, slot-head screwdriver
PARTS SUPPLIED
• 6 Brass screws (3 required, 3 extra)
• 5 Color-matched screws (4 required, 1 extra)
• Bottom trim
21-1/2”
13”
1-3/10”
1-4/5”
1”
26-3/4”
18-5/8”
NOTE: Appearance may vary slightly by model.
ADVANCE PLANNING
• These ovens may be installed directly into
a 27”-wide oven cabinet.
• The front surface of the oven will be nearly flush
with surrounding cabinetry doors.
• This oven can be installed over any GE single
electric built-in oven or a warming drawer or both.
IMPORTANT: This oven is not approved for use
above another built-in SpeedCook oven, a side-by-
side installation or below a countertop.
• For personal safety, this oven cannot be installed
in a cabinet arrangement such as an island or
peninsula.
• The oven must be installed at least 36-3/4” above
the floor.
• Allow for clearance to adjacent corners, walls,
drawers, etc.
• Cabinets installed adjacent to wall ovens must
have
an adhesion spec of at least 194ºF temperature
rating.
The oven must be securely installed in a cabinet
that is firmly attached to the house structure.
Weight on the oven door could cause the oven to
tip and result in injury. Never allow anyone to climb,
sit, stand or hang on the oven door.
Design Information