PSB9240DF PSB9240SF PSB9240BL PSB9240EF ZSC2200 ZSC2201 ZSC2202

9
Installation Preparation
Preparation WITH an Accessory Storage Drawer
NOTE: MODEL ZSC2202 CANNOT BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER. SEE
INSTALLATION PREPARATION WITHOUT AN ACCESSORY STORAGE DRAWER FOR THIS MODEL.
PREPARE THE OPENING (CONT.)
Installation over a Wall Oven and
Warming Drawer:
* For existing cutouts, a maximum width of
28-1/2” is acceptable. If the opening is slightly
wider, secure a furring strip on each side of the
cutout for securing the oven.
NOTE: Additional clearances between the cutouts
may be required. Check to be sure the oven
supports above the Warming Drawer location do
not obstruct the required interior depth and height.
See Warming Drawer installation instructions for
details.
CAUTION
For personal safety, the
mounting surface must be capable of supporting
the cabinet load, in addition to the added weight
of the oven and drawer, plus additional oven
loads.
PRECAUCIÓN
Para su seguridad
personal, la superficie de montaje deberá
poder soportar la carga del gabinete, además
del peso agregado al horno y al cajón, junto
con las cargas adicionales en el horno.
Construct
Solid Bottom
Min. 3/8”
Plywood
Supported
by
2x4 or 2x2
Runners all
Four Sides
30”
23-1/2”
21”
2” Min.
Per Oven
Requirement
45-1/4”
Min.
PREPARE THE OPENING (CONT.)
Installation over a Wall Oven:
* For existing cutouts, a maximum width of
28-1/2” is acceptable. If the opening is slightly
wider, secure a furring strip on each side of the
cutout for securing the oven.
• If you are replacing an electric double oven
with the combined installation of
an Advantium 240V and a single oven, use the
dimensions shown. The middle rail separating
the two openings may need to be larger than
the 2” minimum shown.
30”
23-1/2”
25-1/4”
Min.*
21”
45-1/4”
Min.
Construct
Solid Bottom
Min. 3/8”
Plywood
Supported by
2x4 or 2x2
Runners all
Four Sides
Per Oven
Requirement
25-1/4”
Min.*
2” Min.
(3” recommended)
2” Min.
(3” recommended)
Per warming drawer requirement