PV970 PV976

 49-2000916 Rev. 0
Installation Instructions
INSTALLATION INSTRUCTIONS
INSTALLATION - RECIRCULATING
DUCTWORK, WIRING LOCATIONS
Ŷ'HWHUPLQHWKHH[DFWORFDWLRQRIWKHYHQWKRRG
Ŷ/RFDWHWKHWHPSODWHSDFNHGZLWKWKHOLWHUDWXUH
Ŷ0HDVXUHIURPWKHIORRUWRWKHWRSRIWKHFRRNLQJ
surface. Add hood installation height determined
RQSDJHVDQG0DUNWKDWORFDWLRQ
Ŷ7DSHWKHWHPSODWHLQSRVLWLRQDORQJWKHSHQFLOHG
line. CHECK TO BE SURE THE TEMPLATE IS
LEVEL.
Ŷ8VHDOHYHOWRGUDZDOLQHVWUDLJKWXSIURPWKH
centerline on the template to the ceiling.
HOUSE WIRING LOCATION:
Ŷ7KHMXQFWLRQER[LVORFDWHGRQWKHWRSOHIWVLGHRI
the hood.
Ŷ:LULQJVKRXOGHQWHUWKHEDFNZDOODWOHDVW´
above the bottom of the hood, and within 5” of the
centerline.
STEP 1: INSTALL FRAMING FOR
HOOD SUPPORT
IMPORTANT: Framing must be capable of
supporting 100 lbs.
If drywall is present, mark the screw hole locations
for the top mounting brackets. Remove the
template.
Ŷ&XWDZD\HQRXJKGU\ZDOOWRH[SRVHYHUWLFDO
studs at the bracket location indicated on the
template.
Ŷ,QVWDOODKRUL]RQWDOVXSSRUWDWOHDVW´[´
between two wall studs at the mounting screw
location. The horizontal support must be flush
with the room side of the studs. Use cleats
behind both sides of the support to secure to wall
studs.
NOTE: 2 horizontal supports will be needed if there
is a stud located between the horizontal screw
locations (see figure).
IMPORTANT: Reinstall drywall for an even
mounting surface.
REAR WALL
MOUNTING TEMPLATE
Vertical Centerline
ALIGN BOTTOM EDGE
WITH PENCIL LINE
INDICATING BOTTOM
OF THE HOOD
11-7/16"
Installation Height
Horizontal Line
C
L
DRILL 2 (TWO) 3/16" PILOT HOLES THROUGH STUDS OR REAR WALL SUPPORT
10-1/8"
12-08 JR
2"
DRILL 2 (TWO) 3/16" PILOT HOLES THROUGH STUDS OR REAR WALL SUPPORT
12-1/2"
WALL VENT IS 27-3/4" MIN.
ABOVE THE INSTALLATION
HEIGHT
31-14772 Printed in Mexico
Ceiling
House Wiring
Location
C
L
5”
´
Min.
5” c enterline to wall
View from
rear cleats
1” x 12” min.
mounting
support
Centerline of
installation
space