PV970 PV976

49-2000916 Rev. 0 19
Installation Instructions
INSTALLATION - RECIRCULATING (Cont.)
INSTALLATION INSTRUCTIONS
STEP 2: INSTALL HOOD MOUNTING
SCREWS
The mounting screws must enter the horizontal
support or wall studs.
Ŷ With the template taped in place, use a punch to
mark mounting bracket screw locations.
Ŷ'ULOO´SLORWKROHVLQRIWKHSXQFKHGORFDWLRQV
in the lower bracket. If the bottom 2 pilot holes
GRQRWHQWHUZRRGHQODUJHWKHKROHVWR´DQG
install metal wall fastener anchors (provided).
Ŷ Remove the template.
Ŷ,QVWDOOWKHWRSPRXQWLQJVFUHZVOHDYH´
gap between the screw head and the wall. This
will allow the keyhole slot on the hood frame to
engage the screw head.
IMPORTANT: Use the mounting screws provided.
DO NOT USE DRYWALL SCREWS.
• Check to be sure the mounting screws are
horizontally level.
STEP 3: INSTALL DUCT BRACKET
AND DEFLECTOR
The duct bracket should be installed against the
EDFNZDOODQGIOXVKZLWKWKHFHLOLQJWKHSRLQW
where the ceiling meets the wall should be level
for the bracket and duct cover to fit flush. This
bracket will hold the duct cover in place at the top.
Secure the bracket to the wall:
Ŷ Align the diamond centerline cutout on the
bracket to the penciled centerline on the wall.
Ŷ Mark 2 screw hole locations in the wall.
Ŷ 'ULOO´SLORWKROHVLQWKHPDUNHGORFDWLRQV
Ŷ If pilot holes do not enter wood studs, enlarge
WKHKROHVWR´DQGLQVWDOOPHWDOZDOOIDVWHQHU
anchors (provided).
Ŷ If mounting directly to a masonry wall, obtain
appropriate #10 masonry screw anchors.
Drill and install per the fastener supplier’s
instructions.
Ŷ Drive screws, by hand, into the fasteners to
allow anchors to expand. Remove the screws.
Ŷ Secure the bracket to the wall with wood screws
DQGRUIDVWHQHUV
Ŷ Assemble the air deflector accessory to the
duct cover bracket with the 4 assembly screws
provided. DO NOT tighten screws. This is a
temporary installation.
REAR WALL
MOUNTING TEMPLATE
Vertical Centerline
ALIGN BOTTOM EDGE
WITH PENCIL LINE
INDICATING BOTTOM
OF THE HOOD
11-7/16"
Installation Height
Horizontal Line
C
L
DRILL 2 (TWO) 3/16" PILOT HOLES THROUGH STUDS OR RE AR WALL SUPPORT
10-1/8"
12-08 JR
2"
DRILL 2 (TWO) 3/16" PILOT HOLES THROUGH STUDS OR REAR WALL SUPPORT
12-1/2"
WALL VENT IS 27-3/4" MIN.
ABOVE THE INSTALLATION
HEIGHT
31-14772 Printed in Mexico
Centerline cutout