Full Product Manual

1. Plug the surge protector into a standard grounding duplex wall
receptacle, covering both outlets, by fully inserting the blades and ensure
that there are no exposed conductors.
2. The surge protector will now be providing power and surge protection.
3. Make sure electronic equipment is turned off before plugging into
the surge protector outlets. Do not use extension cords to connect
equipment to the surge protector.
4. Connected equipment can now be turned on.
5. Hold the surge protector firmly against wall when removing plugs to
prevent it from pulling loose.
USB Charging
• 1.0 Amp total output allows you to charge two smartphones at full
capacity at the same time. Recharge your device at a maximum speed
of 1.0 Amp when connected to a single port.
• The USB ports are used to charge portable electronic devices only. There
is no data transfer capability.
NOTE: Check the blue “PROTECTED” indicator light periodically. A glowing
blue indicator light shows that surge protection is being provided. If the blue
“PROTECTED” indicator light stops glowing, the surge protective components
have expired — though power will still be supplied to the outlets, now
unprotected. To ensure the protection of your electronics the surge protector
should be replaced.
Surge Protector — Limited-Lifetime Warranty
Jasco Products Company warrants this surge protector to be free of
defects in workmanship and/or materials for the life* of the surge protector. If
such a defect should arise during the life of the surge protector, Jasco Products
Company will, at its option, either repair or replace the surge protector without
charge. This warranty does not cover damage caused by lightning, accident,
misuse, or alterations to the surge protector.
* This surge protector, like all surge protectors, has a finite lifespan. Even
under normal circumstances and in the absence of defects, the product’s
life will expire when the surge protector’s component capacity has
been exceeded, thereby ceasing to provide protection from surges.
Warranty replacement procedure
1. Call Jasco Products Company Customer Information Center at
1-800-654-8483 to get a Return Authorization Number (RA#), shipping
instructions and a prepaid return address label.
2. Return the Jasco Products Company surge protector, freight prepaid, to
Jasco Products Company. Surge protectors returned to Jasco Products
Company must have an RA# included in the mailing address to be accepted.
3. The original purchaser will be asked to send the surge protector, a copy
of the sales receipt for the product, your name, address, phone number
and a description of the problem.
Connected Equipment Warranty
Equipment Replacement Guarantee for Surge Model: 14512
Maximum Warranty Amount: $25,000(USD)
NOTE: This device is not a lightning arrestor, so it will not afford protection
when lightning strikes nearby power line, the house, service entrance
or antenna. The warranty is void if a power disturbance damages your
equipment through the coax, phone or network lines.
Jasco Products Company will pay up to the maximum warranty amount
offered for the surge protector purchased to repair or replace up to an
amount equal to the fair market value or the original purchase price,
whichever is less, of your electronics equipment, if damaged by a transient
surge (except those caused by direct lightning), within the life* of the
surge protector, while properly and directly connected to this surge
protector. JASCO PRODUCTS COMPANY DISCLAIMS AND ASSUMES NO
LIABILITY FOR ANY OTHER INCIDENTAL OR CONSEQUENTIAL DAMAGES,
INCLUDING BUT NOT LIMITED TO LOSS OR DAMAGE TO SOFTWARE OR DATA
OR DAMAGES OR COSTS ASSOCIATED WITH BUSINESS INTERRUPTION OR
OTHER DAMAGES DUE TO LOSS OR DAMAGE TO EQUIPMENT, SOFTWARE OR
DATA. Some states do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitation or exclusion may not apply
to you. This warranty gives you specific legal rights, and you may also have
other rights that may vary from state to state.
This warranty is secondary to any existing coverage of any connected
equipment, including but not limited to, any manufacturer’s warranty,
extended warranties, or insurance coverage.
To qualify for a connected equipment warranty:
1. All connected equipment must be UL and/or CSA approved.
2. The Jasco Products Company surge protector must be plugged into
properly wired and grounded outlets, no extension cords, adapters,
other ground wires or electrical connectors may be used, with the sole
exception of other standard Jasco Products Company 120 volt products
approved for that use. The installation must comply with all applicable
electrical and safety codes set forth pursuant to the National Electrical
Code (NEC).
3. Any claim under the warranty policy must be made within 15 days of the
date of the alleged damage to the connected equipment.
For connected equipment coverage, the following conditions must
be satisfied:
A) All equipment eligible for warranty coverage must be plugged directly
into the Jasco Products Company surge protector. Equipment connected
to the protected equipment, but not plugged directly into the surge
protector will not be covered.
B) The equipment must have been damaged by a covered power
disturbance that passed through the Jasco Products Company surge
protector.
C) The Jasco Products Company surge protector must be damaged from
the power disturbance.
D) The Jasco Products Company surge protector’s protection capacity must
not have been exceeded.
Connected equipment claim procedure:
1. Call Jasco Products Company Customer Information Center at 1-800-654-
8483 to get a Return Authorization Number (RA#), shipping instructions
and a prepaid return address label.
2. After you have received the prepaid return address label, return the
Jasco Products Company surge protector, freight prepaid, to Jasco
Products Company. Surge protectors returned to Jasco Products
Company, Inc. must have an RA# included in the mailing address to be
accepted.
3. Jasco Products Company will determine whether the damage to your
equipment is covered by this warranty policy. If you are covered, a claims
adjuster will contact you and Jasco Products Company will do one of the
following at its own discretion:
a) Authorize a service center to repair damaged equipment.
b) Replace damaged equipment with equivalent or better.
c) Reimburse customer the fair market value of the damaged
equipment.
d) Reimburse customer the initial purchase price of the damaged
equipment (customer to provide dated bill of sale).
4. Jasco Products Company retains the right to determine whether the
damage to the connected equipment is due to Jasco Products Company
surge protector failure by requesting that damaged equipment be sent
to Jasco Products Company for inspection.
FCC Statement
This device complies with Part 15 of the FCC rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC NOTE: The manufacturer is not responsible for any radio or TV
interference caused by unauthorized modifications to this equipment. Such
modifications could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
NOTE: This device features an internal protection that will disconnect the
surge protective component at the end of its useful life but will maintain
power to the outlets – now unprotected. If the indicator light goes out, this
unit will no longer provide surge protection as intended and
should be replaced.
MADE IN CHINA
GE is a trademark of General Electric Company and
is under license by Jasco Products Company LLC,
10 E. Memorial Rd., Oklahoma City, OK 73114.
This Jasco product comes with a limited-lifetime
warranty. Visit www.byjasco.com for warranty details.
Questions? Contact us at 1-800-654-8483 between
7:00AM—8:00PM CST.
14512 v3
03/07/17 CH
Surge Protector
Instructions