Instructions / Assembly

Surge Protector Instructions
1. Plug the surge protector into a standard grounding wall receptacle by fully
inserting the plug and ensure that there are no exposed conductors.
2. The surge protector will now be providing power and surge protection.
3. Make sure electronic equipment is turned off before plugging into the surge
protector outlets. Do not use extension cords to connect equipment to the
surge protector.
4. Connected equipment can now be turned on.
NOTE: Check the red “Protected” indicator light and green “Grounded” periodically.
A glowing red indicator light shows that surge protection is being provided. A
glowing green indicator light shows that the wall receptacle is properly grounded.
If the red “PROTECTED” indicator light stops glowing, the surge protective
components have expired* and the power has been permanently shut down to the
outlets, ensuring surge protection for your electronic equipment.
Surge Protector —Limited Lifetime Warranty
Jasco Products Company warrants this surge protector to be free of defects in
workmanship and/or materials for the life* of the surge protector. If such a defect
should arise during the life of the surge protector, Jasco Products Company
will, at its option, either repair or replace the surge protector without charge.
This warranty does not cover damage caused by lightning, accident, misuse, or
alterations to the surge protector.
* This surge protector, like all surge protectors, has a fi nite lifespan. Even under
normal circumstances and in the absence of defects, the product’s life will expire
when the surge protector’s component capacity has been exceeded, thereby
ceasing to provide protection from surges.
Warranty Replacement Procedure
1. Call Jasco Products Company Customer Information Center at
1-800-654-8483 to get a Return Authorization Number (RA#), shipping
instructions and a prepaid return address label.
2. Return the Jasco Products Company surge protector, freight prepaid, to Jasco
Products Company. Surge protectors returned to Jasco Products Company
must have an RA# included in the mailing address to be accepted.
3. The original purchaser will be asked to send the surge protector, a copy of
the sales receipt for the product, your name, address, phone number and a
description of the problem.
Connected Equipment Warranty
Equipment Replacement Guarantee for Surge Model: 14913
Maximum Warranty Amount: $60,000
NOTE: This device is not a lightning arrestor, so it will not afford protection when
lightning strikes nearby power line, the house, service entrance or antenna. The
Warranty is void if a power disturbance damages your equipment through the
phone, data network or coaxial lines. You are only covered if the disturbance
entered through the AC lines.
Jasco Products Company will pay up to the maximum warranty amount offered
for the surge protector purchased to repair or replace up to an amount equal
to the fair market value or the original purchase price, whichever is less, of your
electronics equipment, if damaged by a transient surge (except those caused by
direct lightning), within the life* of the surge protector, while properly and directly
connected to this surge protector. JASCO PRODUCTS COMPANY DISCLAIMS
AND ASSUMES NO LIABILITY FOR ANY OTHER INCIDENTAL OR CONSEQUENTIAL
DAMAGES, INCLUDING BUT NOT LIMITED TO LOSS OR DAMAGE TO SOFTWARE
OR DATA OR DAMAGES OR COSTS ASSOCIATED WITH BUSINESS INTERRUPTION
OR OTHER DAMAGES DUE TO LOSS OR DAMAGE TO EQUIPMENT, SOFTWARE
OR DATA. Some states do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitation or exclusion may not apply to
you. This warranty gives you specifi c legal rights, and you may also have other
rights that may vary from state to state.
This warranty is secondary to any existing coverage of any connected equipment,
including but not limited to, any manufacturer’s warranty, extended warranties,
or insurance coverage.
To qualify for a warranty:
1. All connected equipment must be UL and/or CSA approved.
2. The Jasco Products Company surge protector must be plugged into properly
wired and grounded outlets, no extension cords, adapters, other ground
wires, or electrical connectors ma be used, with the sole exception of other
standard Jasco Products Company 120 volt products approved for that use.
The installation must comply with all applicable electrical and safety codes set
forth pursuant to the National Electrical Code (NEC.)
3. Any claim under the warranty policy must be made within 15 days of the date
of the alleged damage to the connected equipment.
For Connected Equipment coverage, the following conditions must be satisfi ed:
A.) All equipment eligible for warranty coverage must be plugged directly into
the Jasco Products Company surge protector. Equipment connected to the
protected equipment, but not plugged directly into the surge protector will
not be covered.
B.) The equipment must have been damaged by a covered power disturbance
that passed through the Jasco Products Company surge protector.
C.) The Jasco Products Company surge protector must be damaged from the
power disturbance.
D.) The Jasco Products Company surge protector’s protection capacity must not
have been exceeded.
Connected Equipment Claim Procedure:
1. Call Jasco Products Company Customer Information Center at 1-800-654-8483 to
get a Return Authorization Number (RA#), shipping instructions and a prepaid
return address label.
2. Return the Jasco Products Company surge protector, freight prepaid, to Jasco
Products Company. Surge protectors returned to Jasco Products Company, Inc.
must have an RA# included in the mailing address to be accepted.
3. Jasco Products Company will determine whether the damage to your
equipment is covered by this warranty policy. If you are covered, a claims
adjuster will contact you and Jasco Products Company will do one of the
following at its own discretion:
a.) Authorize a service center to repair damaged equipment.
b.) Replace damaged equipment with equivalent or better.
c.) Reimburse customer the fair market value of the damaged equipment.
d.) Reimburse customer the initial purchase price of the damaged equipment
(customer to provide dated bill of sale).
4. Jasco Products Company retains the right to determine whether the damage
to the connected equipment is due to Jasco Products Company surge protector
failure by requesting that damaged equipment be sent to Jasco Products
Company for inspection.
14913 vers. 2 8/12
is a trademark of General Electric Company and is
under license by Jasco Products Company LLC,
10 E. Memorial Rd., Oklahoma City, OK 73114.
www.jascoproducts.com