User guide

is a trademark of General Electric
Company and is used under license to
Jasco Products Company LLC, 10 E.
Memorial Road, Oklahoma City, OK 73114
www.jascoproducts.com
1.8125" 1.8125" 1.8125" 1.8125"
1.8125"
2.9375"
INSTRUCTION MANUAL
Questions? Call 1-800-654-8483
WARNING
Heavy Duty Outdoor
WIRELESS OUTLET
RECEIVER
with Key Chain Transmitter
ENCLOSED YOU WILL FIND
• Outdoor Receiver
• Key Chain Transmitter
• 12-volt Alkaline Battery
(installed)
The Receiver and the Transmitter are randomly
preprogrammed at the factory to one of six channel
settings. These channel settings are defined as either: A,
B, C, D, E or F and are marked on the back of each
product. A single GE Wireless Remote Control
transmitter can control multiple receivers if they all have
the same channel setting. Also, multiple GE Wireless
Remote Control transmitters can control one receiver if
they all have the same channel setting.
This transmitter/receiver pair is NOT compatible with
GE SmartHome™ remotes.
Compliance with IC Rules and Regulations
IC: 3653A-R1G0030R (REMOTE)
3653A-PT446A (RECEIVER)
Company: Jasco Products Company
Model Number: R1G0030R (REMOTE)
PT-448B (RECEIVER)
Object is subjected to the following two conditions.
This device may not cause interference, and this device must accept
any interference, including interference that may cause undesired
operation of the device.
This class B digital apparatus complies with Canadian ICES-003.
OPERATING INSTRUCTIONS
1. Plug Outdoor Receiver into a GFCI protected
receptacle. Make sure unit hangs freely with
receptacle down and away from wet locations.
2. Plug light or appliance into Outdoor Receiver.
3. Make sure outlet supplying Outdoor Receiver is
powered.
4. Make sure light or appliance is turned ON.
IMPORTANT: The lamp or appliance will
remain OFF until the Outdoor Receiver is
activated by the Transmitter.
You can now control your lamp or appliance
remotely using the Transmitter. A light on
the Outdoor Receiver turns on when the
unit is activated remotely, indicating that
power is being supplied to the lamp or
appliance.
IMPORTANT: Make sure to press toggle
button on Transmitter firmly for a minimum
of 1 second for best results.
A light on the Key Chain Transmitter turns on when the
toggle button is activated, indicating that an ON or OFF
signal is being sent. If indicator light is not activated by
pressing the toggle switch, replace the battery (USE
ONLY 12V type A23 Alkaline).
REPLACING BATTERY
1.Remove battery cover.
2.Remove old battery.
3.Install new 12V type A23 alkaline battery noting
polarity.
4.Replace battery cover.
SPECIFICATIONS:
OUTDOOR RECEIVER
FOR INDOOR USE ONLY
CAUTION: DO NOT EXCEED ELECTRICAL RATINGS
Functional Range ....................................up to 100ft
Maximum Resistive Load ............................ 1440W
Maximum Tungsten Load .............................. 1000W
Rating ..................... 120V, 60Hz 1/3 HP Motor Load
KEY CHAIN TRANSMITTER
CAUTION: DO NOT EXCEED ELECTRICAL RATINGS
Functional Range ....................................up to 100ft
Battery Type ................ Use only 12V Alkaline A23
* Functional range may be adversely affected by one or
more of the following factors: weather, radio frequency
interference, low transmitter battery and obstructions
between the transmitter and receiver.
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
FCC NOTE: The manufacturer is not responsible for any radio or TV interference
caused by unauthorized modifications to this equipment. Such modifications
could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
0
15259-2 rev. 11.12.09
Risk of electric shock
• Keep children away
• Do not use in wet locations
• Fully insert plug
• When used outdoors, plug directly into
a GFCI Protected electrical outlet
Risk of fire
• Do not exceed electrical ratings