Owner manual

INSTALLATION
4. Connect the Power Cord
Plug the right angle plug on the power cord
in to the "POWER" jack at the rear of the
unit.
5. Plug In the Power Supply
Plug the power supply into the 110 VAC
power outlet. A power-up tone will be heard
and the MESSAGES display will read "00".
The ANNOUNCE 1 and ANNOUNCE 2 LED's
will flash.
Note: If message display flashes "00" and
"Lo". then the unit does not detect a fresh 9V
battery in place.
0 1 6 1 r A 1
o o
MMMCV f 4MCM*Cr/
cncn
«rvrv
C3I=3[H3
o
o o O
6 o o
omtAm