Instructions / Assembly

FINISHING THE FAN INSTALLATION

Fan Installation

ATTACHING THE FAN BLADES

Position the blade (L) over the blade holder (K) with the

threaded post upward direction as shown. Make sure

bottom edge of the blade (L) is fully seated against the

blade holder (K). With a phillips screwdriver, tighten the

blade screw (FF) to secure the blade to the blade holder (K).

Remove and discard the preassembled plastic motor

blocks but retain the blade holder screws (EE). Secure the

blade holders (K) to the bottom of the motor assembly (E)

using the blade holder screws (EE).

Plastic

motor block

Tighten all the 4 canopy mounting screws (O).

into place on the canopy (B).

10.

Align the slotted hole on the canopy trim ring (C) with

the mounting bracket push lever, Take both hands

and push the canopy trim ring (C) up to the top of the

canopy (B). The canopy trim ring (C) will snap and lock

Groove

Tab

Make sure the tab on the mounting bracket socket

is properly seated in the groove in the hanger ball/

downrod assembly. This will help to balance the

ceiling fan.

WARNING: Failure to properly seat the tab in the

groove could cause damage to wiring.

Rotate the canopy to the right (clockwise), continue

turning the canopy until the screws (O) lock into

place on the receptacle j slots.

Note: You may need to loosen the canopy screws

slightly, if you find it's difficult to lock the screws

into the receptacle j slots.