Instructions / Assembly
INSTALLING THE LIGHT KIT ASSEMBLY
1.
Fan Installation
F
E
2.
To install the light kit assembly (F),
attach the 9-pin connector from light
kit assembly (F) to the 9-pin connector
from motor assembly (E). Then attach the
light kit assembly (F) with the mounting
plate using screws removed in step 1.
Tighten securely. Note:The two connectors
have keyholes that must be mated
correctly before they can be engaged.
3.
Install the light bulbs into each socket.
Use Max 3 X 10W self-ballasted
LED bulbs (G) (included)
Note: Before starting installation, disconnect the power by turning off the circuit breaker or removing the fuse at fuse box.
Turning power off using the fan switch is not sufficient to prevent electric shock.
9-pin
connector
S
Remove the three switch housing screws (S) preassembled on mounting plate of motor housing and save for later use.
Note: To install the fan with light kit assembly, proceed to steps below. If you do not want to install the light kit assembly
proceed to the section “INSTALLING WITHOUT THE LIGHT KIT ASSEMBLY”.
4.
Place glass bowl (H) through threaded
stem. Add the finial cap (I) and secure
with the finial nut (J). Make sure the
glass is completely secured in place.
G
H
I
J
INSTALLING WITHOUT THE LIGHT KIT ASSEMBLY
F
5.
Disconnect the single pin connectors
in light kit assembly and remove the
two screws on the outside of the
light kit assembly (F).
6.
Attach the reverse switch to
the optional switch housing (M)
with the two screws removed
on previous step.
Note : Make sure to attach the
reverse switch with double-yellow
wire as shown in the above picture
so the reverse function works
normally.
7.
Attach the 9-pin connector from the
optional switch housing (M) to the 9-pin
connector from motor assembly.
Note: The two connector have keyholes
that must be mated correctly before
they can be engaged. Attach the
optional switch housing (M) to mounting
plate using the three screws removed
in step 1. Tighten securely.
M
M
9-pin connector
Note: The LED bulb is without dimming
feature.
double-yellow
wire（downward)
13