Instructions / Assembly

Fan Installation

ATTACHING THE FAN BLADE

Attach the blade (I) and blade support plate (J) to the motor

assembly (E), secure with five blade screws (EE). Tip : Secure

1 screw to the motor assembly (E) to help line up the other

holes in the motor, then secure the blade to the motor with

the remaining 4 screws. Repeat for the remaining blades,

tighten all screws.

The blade holder decoration (K) is a part which fits

between the blades. Attach a blade holder decoration

(K) to the motor assembly (E), align the red dot label

on the blade holder decoration (K) to red dot on the

motor assembly (E), insert the two protrusions on the

blade holder decoration (K) into the small holes on the

motor assembly (E). Secure with two blade holder

decoration screws (FF). Repeat for the remaining blade

holder decorations (K).

red dot label

protrusion

HANG FAN

Tighten all the 4 canopy mounting screws (M).

To insert canopy trim ring (C), align the slotted hole on the

canopy trim ring (C) with the mounting bracket push lever,

take both hands and push the canopy trim ring (C) up to

the top of the canopy (B). The canopy trim ring (C) will snap

and lock into place on the canopy (B).

Groove

Tab

Rotate the canopy to the right (clockwise), continue

turning the canopy until the screws (M) lock into

place on the receptacle j slots.

Note: You may need to loosen the canopy screws

slightly, if you find it's difficult to lock the screws into

the receptacle j slots.

Make sure the tab on the mounting bracket socket

is properly seated in the groove in the hanger ball/

downrod assembly. This will help to balance the

ceiling fan.

WARNING: Failure to properly seat the tab in the

groove could cause damage to wiring.