Full Product Manual

Programming Your Remote, cont.

Auto Code Search

The Auto Code Search searches automatically through

the codes stored in this remote. Read all the following

steps prior to starting the auto code search as you will

need to be prepared to lock-in the proper code when

found.

1. Manually turn on the device you wish

to control.

2. Press and hold the SETUP button

until the red indicator light stays on

(approximately 2 seconds) and then

release the button.

3. Press and release the desired device

button on the remote (TV, CBL, DVR,

DVD, SAT, AMP, AUX 1, AUX 2) the

type of device you wish to control. The

red indicator will blink once and then

remain on.

4. Point the remote at the device and

press and release the POWER

button (for TV) or PLAY button (for

DVD, VCR, etc.) to start the search. The

red indicator will ﬂash

(approximately every 2 seconds) as

the remote searches. Note: The remote

must be pointed at the device for the

duration of this search.

5. Place your ﬁnger on the #1 button so

you are prepared to lock-in the code.

6. When the device shuts off or begins

playing, press the #1 button to lock-in

the code. The red indicator light will

turn off. Note: You have approximately

two seconds after the device shuts off

or begins playing to lock-in the code.

7. Point the remote at the device and

check to see if the remote operates

the device as desired. If it does, no

further programming is required for

that device. If it does not, return to step

2 and start the auto code search again.