Full Product Manual

Surge Protector Instructions
1. Plug the surge protector into a standard grounding duplex wall receptacle, covering both
outlets, by fully inserting the plug. Ensure that there are no exposed conductors.
2. The surge protector will now be providing power and surge protection.
3. Make sure electronic equipment is turned off before plugging into the surge protector
outlets. Do not use extension cords to connect equipment to the surge protector.
4. Connected equipment can now be turned on.
5. Hold the surge protector firmly against wall when removing plugs to prevent it from
pulling loose.
NOTE: Check the blue “PROTECTED” indicator light periodically. A glowing blue indicator light
shows that surge protection is being provided. If the blue “PROTECTED” indicator light stops
glowing, the surge protective components have expired — though power will still be supplied to
the outlets, now unprotected. In this event, the Connected Equipment Warranty is no longer
valid and the surge protector should be replaced.
Surge Protector — Limited-Lifetime Warranty
Jasco Products Company warrants this surge protector to be free of defects in workmanship
and/or materials for the life* of the surge protector. If such a defect should arise during the life
of the surge protector, Jasco Products Company will, at its option, either repair or replace the
surge protector without charge. This warranty does not cover damage caused by lightning,
accident, misuse or alterations to the surge protector.
* This surge protector, like all surge protectors, has a finite lifespan. Even under normal
circumstances and in the absence of defects, the product’s life will expire when the surge
protector’s component capacity has been exceeded, thereby ceasing to provide protection
from surges. In this event, the limited-lifetime warranty is no longer valid and the surge
protector should be replaced.
Warranty replacement procedure
1. Call Jasco Products Company Customer Information Center at
1-800-654-8483 to get a Return Authorization Number (RA#), shipping instructions and a
prepaid return address label.
2. After you have received the prepaid return address label, return the Jasco Products
Company surge protector, freight prepaid, to Jasco Products Company. Surge protectors
returned to Jasco Products Company must have an RA# included in the mailing address to
be accepted.
3. The original purchaser will be asked to send the surge protector, a copy of the sales receipt
for the product, their name, address, phone number and a description of the problem.
Connected Equipment Warranty
Equipment Replacement Guarantee for Surge Model: 33651
Maximum Warranty Amount: $25,000(USD)
NOTE: This device is not a lightning arrestor, so it will not afford protection when lightning strikes
nearby power line, the house, service entrance or antenna. The Warranty is void if a power
disturbance damages your equipment through the coax, phone or network lines.
Jasco Products Company will pay up to the maximum warranty amount offered for the surge
protector purchased to repair or replace up to an amount equal to the fair market value or
the original purchase price, whichever is less, of your electronics equipment, if damaged by a
transient surge (except those caused by direct lightning), within the life* of the surge protector,
while properly and directly connected to this surge protector. JASCO PRODUCTS COMPANY
DISCLAIMS AND ASSUMES NO LIABILITY FOR ANY OTHER INCIDENTAL OR CONSEQUENTIAL
DAMAGES, INCLUDING BUT NOT LIMITED TO LOSS OR DAMAGE TO SOFTWARE OR DATA OR
DAMAGES OR COSTS ASSOCIATED WITH BUSINESS INTERRUPTION OR OTHER DAMAGES DUE TO
LOSS OR DAMAGE TO EQUIPMENT, SOFTWARE OR DATA. Some states do not allow the exclusion
or limitation of incidental or consequential damages, so the above limitation or exclusion may
not apply to you. This warranty gives you specific legal rights, and you may also have other
rights that may vary from state to state.
This warranty is secondary to any existing coverage of any connected equipment, including
but not limited to, any manufacturer’s warranty, extended warranties, or insurance coverage.
To qualify for a connected equipment warranty:
1. All connected equipment must be UL and/or CSA approved.
2. The Jasco Products Company surge protector must be plugged into properly wired and
grounded outlets, no extension cords, adapters, other ground wires or electrical connectors
may be used, with the sole exception of other standard Jasco Products Company 120 volt
products approved for that use. The installation must comply with all applicable electrical
and safety codes set forth pursuant to the National Electrical Code (NEC).
3. Any claim under the warranty policy must be made within 15 days of the date of the alleged
damage to the connected equipment.
For connected equipment coverage, the following conditions must
be satisfied:
A) All equipment eligible for warranty coverage must be plugged directly into the Jasco
Products Company surge protector. Equipment connected to the protected equipment, but
not plugged directly into the surge protector will not be covered.
B) The equipment must have been damaged by a covered power disturbance that passed
through the Jasco Products Company surge protector.
C) The Jasco Products Company surge protector must be damaged from the power
disturbance.
D) The Jasco Products Company surge protector’s protection capacity must not have been
exceeded.
Connected equipment claim procedure:
1. Call Jasco Products Company Customer Information Center at 1-800-654-8483 to get a Return
Authorization Number (RA#), shipping instructions and a prepaid return address label.
2. After you have received the prepaid return address label, return the Jasco Products
Company surge protector, freight prepaid, to Jasco Products Company. Surge protectors
returned to Jasco Products Company, Inc. must have an RA# included in the mailing address
to be accepted.
3. Jasco Products Company will determine whether the damage to your equipment is covered
by this warranty policy. If you are covered, a claims adjuster will contact you and Jasco
Products Company will do one of the following at its own discretion:
a) Authorize a service center to repair damaged equipment.
b) Replace damaged equipment with equivalent or better.
c) Reimburse customer the fair market value of the damaged equipment.
d) Reimburse customer the initial purchase price of the damaged equipment (customer to
provide dated bill of sale).
4. Jasco Products Company retains the right to determine whether the damage to the
connected equipment is due to Jasco Products Company surge protector failure by
requesting that damaged equipment be sent to Jasco Products Company for inspection.
33651
04/25/16
MADE IN CHINA
GE is a trademark of General Electric Company and is
under license by Jasco Products Company LLC,
10 E. Memorial Rd., Oklahoma City, OK 73114.
This Jasco product comes with a limited-lifetime
warranty. Visit www.byjasco.com for warranty details
and product registration.
Questions? Contact us at 1-800-654-8483 between
7:30AM—5:00PM CST.
TO REDUCE THE RISK OF FIRE OR
ELECTRIC SHOCK, DO NOT USE
THIS DEVICE WITH A RECEPTACLE
IN WHICH THE SLOT OPENINGS DO
NOT ALIGN WITH THE BLADES. NOT
FOR USE WITH GROUND-FAULT
CIRCUIT- INTERRUPTER RECEPTACLES
OR RECEPTACLES WITH INDICATOR
LIGHTS OR CONTROLS.
CAUTION