45138 Wireless Alarm System Signal Repeater User’s Manual Choice ALERT™ ™ Control all Sensors & accessories from one location
Table of Contents Important Safeguards 4 Introduction 5 Adding a Signal Repeater to the system 6 Testing the Signal Repeater or your system 7 FCC Warning 8 Before connecting or operating the SIgnal Repeater, please read these instructions carefully and save this manual for future reference.
Congratulations The GE Choice Alert™ Wireless Alarm System is one of the most affordable and expandable wireless alarm systems available. You’ll discover the system offers many features typically found in custom installed Alarm systems. The Choice Alert system is reliable and easy-to-use. With Choice Alert you can select from a line of Sensors and Accessories; start small and expand as you need, or create a system that meets all your needs.
Important safeguards PreCautions 1. Do not attempt to disassemble the Signal Repeater, unless described in the user’s manual. There are no user serviceable parts. 2. Handle with Care – Avoid striking or shaking. Improper use or storage could damage the Signal Repeater. Modifying or tampering the device or its internal components can cause a malfunction and void the Signal Reapeater’s warranty. 3.
Introduction The Signal Repeater will extend the range of the Choice Alert system up to 150 feet from its location – Effectively repeating the signal from any Sensor back to the Control Center should a Sensor be located out of range. The Signal Repeater does not send or receive signals to the Silent Alert or Alarm Siren, or from other Signal Repeaters. Check List Identify all the parts before proceeding.
Adding a Signal Repeater Step 1 - Find an electric outlet near the Sensor having trouble communicating with the Control Center. Make Test certain the location is between the Sensor and Control Center. Plug the Signal Repeater into the outlet and press the ‘Test’ button on the side of Signal Repeater. It will send a test signal out to the Control Center and the LED indicator on the Signal Repeater will flash rapidly for about one second, then go out.
Step 3 - When the Signal Repeater receives the confirmation signal, the LED indicator will flash, five times. If the Signal Repeater does not receive the confirmation signal from the Control Center, the LED indicator on the Signal Repeater will not flash. You will need to move the Signal Repeater closer to the Control Center and retest. Step 4 - To Ensure the Signal Repeater can receive the signal from the Sensor, activate the Sensor.
FCC Warning Any unauthorized changes or modifications to the equipment would void the user’s warranty and may conflict with both state and federal laws. The Choice Alert system complies with part 15 of the FCC rules. Operation is subject to the following conditions: 1) The Choice Alert system may not cause harmful interference. 2) The Choice Alert system may accept any interference received including interference that may cause undesired operation.
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: – Reorient or relocate the receiving antenna. – Increase the separation between the equipment and receiver. – Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
WARNING Limitations of Alarm Products This product should be tested periodically to make sure it is working properly. The product, if used properly, may reduce the risk of burglary, robbery, or other adverse events. However, JASCO is not an insurer, this product is neither insurance nor a guarantee that such an event will be prevented, and users should protect themselves with proper insurance.
of hearing range, muted by doors, walls, and floors, unheard by deep sleepers or the hearing-impaired, or overwhelmed by other sounds.
is a trademark of the General Electric Company and is used under license to Jasco Products Company LLC, 10 E. Memorial Road, Oklahoma City, OK 73114. This Jasco product comes with a 1 year limited warranty. Visit www.jascoproducts.com for details.