Dimensions Guide

For answers to your Monogram,
®
GE Profile
™
or
GE
®
appliance questions, visit our website at
geappliances.com or call GE Answer Center
®
service, 800.626.2000.
36 1/4”
30”
C
L
30”
5”
4”
5”
8”
2”
Recommended area for 120V
outlet on rear wall and area for
through-the-wall connection
of pipe stub and shut-off valve.
Recommended area for
through-the-floor connection
of pipe stub and shut-off valve.
3”
9”
5 1/2”
2 1/2”
14 1/2”
26 1/2”
47”
37 1/4”
30”
+
1/4”
-
+
1/4”
-
Specification Revised 8/11
221225
Electrical Requirements: 240v/208v; 60Hz, 40A
Effective January 1, 1996, the National Electrical
Code requires that new construction (not
existing) utilize a 4-conductor connection to an
electric range.
Receptacle Locations: Locally approved flexible
service cord or conduit must be used because
terminals are not accessible after range
installation. See shaded area in drawing for
location of electrical outlet box. Recommended
outlet locations allow range to be installed
directly against wall.
Note: 30" ranges conform to U.L. requirements
for 0" spacing from adjacent walls below
countertops. To reduce possibility of scorching
walls, engineering recommends a minimum of
1-1/2" spacing to allow for possible extended,
high-heat, no-load heating element operation.
Installation information: Before installing,
consult installation instructions packed with
product for current dimensional data.
Optional accessories: Tall backguard JXS80SS
(Available at additional cost)
All GE ranges are equipped with
an Anti-Tip device. The installation
of this device is an important,
required step in the installation
of the range.
Dimensions and Installation Information (in inches)
C2S985SETSS
GE Café
™
Free-Standing Dual-Fuel Range with Baking Drawer