Installation instructions 30" Induction Cook top if you have questions, call 800.GE.CARES or visit our website at: Noncompliance in Canada, call 800.561.3344 or visit our website at: noncompliance BEFORE YOU BEGIN Read these instructions completely and carefully. + IMPORTANT — dove these instructions for local inspector's use, « IMPORTANT observe al governing codes and ordinances. = Note to Installer Be sure to leave these instructions with the Consumer.
installation Instructions IMPORTANT SAFETY INSTRUCTIONS FOR YOUR SAFETY = For Personal Safety, remove house fuse or open circuit breaker before beginning installation Failure to do so could result in serious injury or death, Be sure your cook top is installed properly by o qualified installer or service technician. To eliminate the risk of burns or fire due to reaching over heated surface elements, cabinet storage located above the surface units should be avoided.
installation Instructions PER-INSTALLATION CHECKLIST BEFORE YOU BEGIN A WARNING The electrical power to the cook top supply line must be shut off while connections are being made. Failure to do so could result in serious injury or death. When preparing cook top opening, make sure the inside of the cabinet and the cook top do not interfere with each other. (See section on preparing the opening.) [el Remove packaging materials and literature package from the cook top before beginning installation.
installation Instructions PREPARING THE OPENING [1] The following MINIMUM clearance dimensions must be maintained. 13" MAX, Depth of recuperated d See lobed next 307 MIN overhead combustible materials or metal cabinets cannot be maintained, a minimum clearance of 24° is required and the underside of the cabinets cove the cook top must be protected with not less thin 1/4" insulating billboard covered with sheet metal not less than 0.0122" thick. [3] VERTICAL CLEARANCES {Cont.
Installation Instructions INSTALLING THE COOK TOP [1] PROTECT SURFACE OF COOK TOP Place a towel or tablecloth onto the counter top. Lay the cook top upside down onto the protected surface. serer of © Cloth under Cook top [2] INSTALL BAFFLE Secure the baffle to the cook top with screws. NOTE: Do not install the baffle when the cook top is installed over a single oven. $ Foe Hex Head { Screws [3] ATTACH FOAM TAPE Apply the foam tape around the outer edge of the gloss. Do not overlap the foam tape.
installation Instructions INSTALLING THE COOK TOP (CONT. [5] INSERT COOK TOP INTO CUTOUT Insert the cook top centered into the cutout opening. Mike sure the front edge of the counter top is parallel to the cook top. Make final check tho all required clearances are met, Heidi Down Bracket Attach Hold Down Brackets to cabinet.
Installation Instructions ELECTRICAL CONNECTIONS NEW CONSTRUCTION AND BRANCH CIRCUIT CONNECTION A WARNING: improper connection of aluminum house wiring to copper leads can result in an electrical hazard or fire. Use only connectors designed for joining copper to aluminum and follow the manufacturer's recommended procedure closely. when making the wire connections, use the entire length of conduit provided, The conduit must not be shortened {unless required by local codes) The conduit length is 4 ft.
installation Instructions CHECKLISTS [1] PER-TEST CHECKLIST [a] Remove all protective film, if present, and any stickers. [EB] Check to be sure that all wiring is secure and not pinched or in contact with moving ports. [£7 check level of appliance. [0] Check tho the cook top is properly grounded. [2] OPERATION CHECKLIST [a] remove all rems from the top of the cook top surface, [Ee] Turn on the power to the cook top. {Refer to your Owner's Manual) Verify that all surface burners operate properly.
Instrucciones de instalación Estufa de inducción de 30” St tiene alguna pregunta, llame a 800.GE.CARES o visite nuestro sitio Web en: GEAppliances.com ANTES DE COMENZAR Lew estas instrucciones por completa y con detenimiento. + IMPORTANTE cuadre estas instrucciones para el uso de inspectores locales. + IMPORTANTE _ Cumpla con todos los códigos y ordenanzas vigentes. + Nota of instalador Asegúrese de dejar estos instrucciones con el consumidor.
instrucciones de inflacionista INSTRUCCIONES DE SEGURIDAD IMPORTANTES PARA SU SEGURIDAD = Para seguridad personal, quite los fusibles o desconecte cortacircuitos antes de comenzar la instalación. No hacerlo puede provocar lo muerte o una lesión personal grave. Verifique que un instalador o un técnico calificados instalen su estufa correctamente.
instrucciones de inflacionista LISTA DE CONTROL PRE-INSTALACIÓN ANTES DE COMENZAR A ADVERTENCIA 0 energía eléctrica de la linea de abastecimiento de la estufa debe estar desconectada mientras se realizan los conexiones. No hacerlo puede provocar lo muerte o una lesión personal grave. Cuando realice uno abertura para lo estufa, verifique que lo parte interna del gabinete v lu estufa ne interfieran entre si. Ver sección sobre la preparación de la abertura.
instrucciones de inflacionista COMO PREPARAR LA ABERTURA 1 Deben mantenerse las siguientes dimensiones INTIMAS de espacio libre. Sino se puede mantener un espacio de 30° entre lo superficie de cocción y el material combustible superior o gabinetes de metal, se requiere un espacio libre mínimo de 24", y el lado inferior de los gabinetes por encima de la estufa debe protegerse con cartón aislante no menor a 1/4” cubierto con ponchas metílicas con un grosor no menor a 0.0122".
Instrucciones de instalación COMO INSTALAR EL ANAFE [1] PROTEJA LA SUPERFICIE DEL ANAFE Coligue una tesalia o mantel sobre lo mesado. Deposite la estufa al revés sobre la superficie protegida. Parte inferior de done boj io estufa [2] INSTALE EL REFLECTOR Sujete el reflector la estufa con los tornillos. NOTA: No instale el reflector cuando lo estufo esta instalado sobre un horno sencillo. colo Que CINTA DE ESPUMA Aplique to cinto de espuma alrededor de los extremos exteriores del vidrio.
instrucciones de inflacionista COMO INSTALAR EL ANAFE (Con) 5] INSERTE LA SUPERFICIE DE COCCIÓN EN EL ENCASTRE Inserte lo estufa centrada en el drene cortado. Aseglares de que el borde frontal del mostrador esté paralelo con respecto a lo estufa, Asegúrese de verificar al final que todos los espacios especificados hayan sido respetados. Adhiera los Soportes al gabinete.
Instrucciones de instalación CONEXIONES ELÉCTRICAS CONEXIÓN DE CONSTRUCCIÓN NUEVA ¥ DE CIRCUITO DERIVADO A ADVERTENCIA: tno cohesiona inadecuada de cablease doméstico de aluminio con coles de cobre puede generar un peligro eléctrico o un incendio. Solo use conectores diseñados para unir cobre con aluminio y siga al pie de la letra el procedimiento recomendado del fabricante.
instrucciones de inflacionista LISTAS DE CONTROL [1] LISTA DE CONTROL PREVIA A LA PRUEBA [a] Quite toda la película protectora, si la hubiera, y todos los comprehensivos. [8] verifique que todo ef cableando esté seguro y que no haya sufrid pellizcos o esté en contacto con partes en movimiento.