user manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Installation
- Chapter 3 Logicmaster 90-70 Configuration
- Chapter 4 Programming Guide
- Overview
- Selecting a Program Block
- Adding the Program Block Logic to an Application Program
- Calling the Program Block
- Program (%P) References for the I/O Link Program Blocks
- Global (%G) References for the I/O Link Program Blocks
- Configuring I/O Links
- Controlling the I/O Link Module
- Monitoring Link Operation
- Index
1
13GFK–0644A Chapter 1 Introduction
Diagnostics
The application Program Block automatically provides the Series 90–70 PLC with
diagnostic information about the I/O Link Interface Module, and about link operation if
the module is operating as a master. The diagnostic information is placed into %P
references assigned to that I/O Link Interface Module. Additional program logic can be
created to read these %P references for monitoring the following:
Whether an invalid configuration has been provided during link initialization. The
link will not operate until a valid configuration has been supplied.
Whether the I/O Link Module is operating properly.
Whether input data is being received.
Whether a link fault has occurred.
Chapter 4 explains how to add these diagnostics to an application program.
Link Control
In addition, the Program Block automatically reads other %P references in the Series
90–70 PLC to receive commands from the application program. These %P references
can be used to instruct the I/O Link Interface Module to do the following:
Operate as a master or a slave.
Disable or enable the input and/or output update between the master and slave(s).
Start or restart link operation.
Reset or stop link operation.
Use of these program references is also explained in chapter 4.