user manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Installation
- Chapter 3 Logicmaster 90-70 Configuration
- Chapter 4 Programming Guide
- Overview
- Selecting a Program Block
- Adding the Program Block Logic to an Application Program
- Calling the Program Block
- Program (%P) References for the I/O Link Program Blocks
- Global (%G) References for the I/O Link Program Blocks
- Configuring I/O Links
- Controlling the I/O Link Module
- Monitoring Link Operation
- Index
2
17GFK-0644A Chapter 2 Installation
Connecting the I/O Link Interface Module to Other Devices
Using the appropriate cable, connect the devices on the I/O Link. Notice that the cables
are marked JD1A on one end and JD1B on the other.
Ports on the I/O Link Module
The functions of the ports on the I/O Link Interface Module depend on whether the
module is used as a master or as a slave.
not
used
Series 90-70
I/O Link
Interface Module
(as slave)
a45016
JD1A
JD1B
JD1B
JD1A
Series 90-70
I/O Link
Interface Module
(as master)
If the system also includes a Series 90–30 PLC, you will notice that the port functions for
the Series 90–30 I/O Link Interface Module are the same as the port functions on the
Series 90–70 I/O Link Interface Module when it is used as a slave.
I/O Link Module Used as a Master
If the module will be used as a master, connect the cable from the first slave to the upper
port. The lower port is not used in master mode.
not
used
JD1B
a45017
JD1A
JD1B