Installation Instructions

Dishwasher Installation

LITERATURE

•

Be sure to leave complete literature package, these Installation

Instructions and product samples and/or coupons with the

consumer.

INSTALL TOEKICK

NOTE: On some models the toekick may come

pre-installed.

• Remove the 2 screws installed on the front brace.

• Place toekick against the legs of the dishwasher.

• Align the toekick with the bottom edge and make

sure it is against the floor.

• Insert and tighten the 2 toekick attachment screws.

The toekick should stay in contact with the floor.

NOTE: Be careful not to over-tighten the screws in

the toekick.

• When reinstalling the toekick, on models with a sound

barrier, ensure that the bottom edge is flush with

the floor. Any excess material should be tucked up

behind the outer door.

Tip: Reduce sound from under the dishwasher.

Make sure toekick is against floor.

Attachment

Screws

Toekick

INSTALL BOTTLE JETS

CLIPS (on some models)

• Locate the 2 Bottle Jets clips, depending on model,

either in the silverware basket or the user bag. Install

a clip over a Bottle Jets stem by slipping its clip end

over the nozzel and pressing it down to the base.

STEP 19

STEP 20

STEP 22

Remove these two screws

CHECK THE FOLLOWING

• Tub trim does not interfere with the door

• Dishwasher is square and level at both the top and

bottom of the cabinet opening, with no twisting or

distortion of the tub or door

• All 4 legs of the dishwasher are firmly in contact with

the floor

• Drain hose is not pinched between the dishwasher

and adjacent cabinets or walls

• Tub trim is fully seated on the tub flange

STEP 21