Specification

ManualsBrandsGE ManualsHousehold Appliance7.2 cu. ft. Electric Dryer in White

Listed by

Underwriters

Laboratories

For answers to your Monogram,

Cafe

™

Series,

Profile

™

Series or GE

appliance questions, visit

our website at geappliances.com or call

GE Answer Center

service, 800.626.2000.

GTD42EASJ

7.2 cu. ft. capacity electric dryer

5.7 cu. ft. Dryers

Back View

Power

Cord Hole

30-1/2

5.8, 6.0 and 7.0 cu. ft. Dryers

Back View

Power

Cord Hole

4-1/2

Power Cord Locations

Electric Dryer Rating:

240V

5600W 24A 60Hz

208V

4400W 22A 60Hz

Exhaust Option: 4-way rear, right, left and bottom

Circuit Requirements: An individual, properly-grounded branch circuit,

protected by a 30-amp circuit breaker or a time-delay fuse, is required.

Note: Dryer wall outlet must be located within 36" of service cord entry

and acessible when dryer is mounted in position.

Installation Information: For complete information, see installation

instructions packed with your dryer.

Dimensions and Installation Information (in inches)

Specification Created 3/15

Special Installation Requirements

Alcove or Closet Installation:

• If your dryer is approved for installation in an alcove or closet, it will be stated on a label

on the dryer back.

• The dryer MUST be exhausted to the outside.

• Minimum clearances between dryer cabinet and adjacent walls or other surfaces are:

0" either side; 3" front and rear

• Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52”.

• Closet doors must be louvered or otherwise ventilated and must contain a minimum

of 60 sq. in. of open area equally distributed. If this closet contains both a washer and

a dryer, doors must contain a minimum of 120 sq. in. of open area equally distributed.

• No other fuel-burning appliance shall be installed in the same closet with a gas dryer.

Bathroom or Bedroom Installation:

• The dryer MUST be exhausted to the outdoors.

• The installation must conform with the local codes, or in the absence of local codes,

with the National Electric Code and National Fuel Gas Code, ANSI Z223 for gas dryers.

Minimum Clearances other than Alcove or Closet Installation:

• Minimum clearances to combustible surfaces are: 0" both sides; 3" rear

Dryer Exhausting Information : Use metal duct only, vertical and horizontal ducting.

Summary of content (3 pages)

PAGE 1
GTD42EASJ GE® 7.2 cu. ft. capacity electric dryer Dimensions and Installation Information (in inches) Electric Dryer Rating: 240V 5600W 24A 60Hz 208V 4400W 22A 60Hz Exhaust Option: 4-way rear, right, left and bottom Circuit Requirements: An individual, properly-grounded branch circuit, protected by a 30-amp circuit breaker or a time-delay fuse, is required. Note: Dryer wall outlet must be located within 36" of service cord entry and acessible when dryer is mounted in position.
PAGE 2
GTD42EASJ GE® 7.2 cu. ft. capacity electric dryer Dryer exhausting information—use metal duct only vertical and horizontal ducting Best performance Maximum length of 4" dia rigid A 4 metal duct B A Exhaust hood type Number A B 4 2-1/2 of 90° 4" 2-1/2" B turns opening opening Domestic dryer models 0 200 ft. 175 ft. 2-1/2 1 185 ft. 165 ft. 2 175 ft. 155 ft. 3 165 ft. 145 ft. GE Frontload Long Vent 7.0 4 155 ft. 135 ft. cu. ft. capacity electric dryer (GFDL) 5 145 ft. 125 ft. 0 150 ft. 125 ft. 1 135 ft.
PAGE 3
GTD42EASJ GE® 7.2 cu. ft.