Gas Range Use and Care & Installation Guide

CLOCK Am TMR
Follow the directions below if your range has the
clock and timer shown at the right.
H [-]
The electronic range clock and timer allow you to set
the timer up to 9 hours and 45 minutes. You have the
choice of having the timer show the time counting
n
--
TIMER
down or the time of day. In either case, the timer will
signal at the end of the timer period to alert you that
the time is up.
To Set the Clock
To Set the Timer
NOTE: When you first plug in the range or after
1. Press the TIMER pad. “:00” appears on the display
a power failure, the entire Cloc~imer display will and “SET TIMER” flashes.
light up. After several seconds
“12:00” will then flash
2. Use the UP and DOWN pads to set the timer.
on the display.
Short taps on the UP or DOWN pad change the
1. Press the CLOCK pad. “12:00” stops flashing
timer’s setting one minute at a time. Pressing and
and “SET TIME” flashes on the display.
continuing to hold the UP pad increases the setting
2. Press and hold the UP or DOWN pad and the time
five minutes at a time until one hour (“1:00”) is
of day will change 10 minutes at a time. To change
displayed. After one hour is displayed, pressing
the time by single minutes, give the pads short taps.
and holding the UP pad increases the setting
For example, to set the clock for 3: 15, press and
15 minutes at a time. (Short taps on the UP and
hold the UP pad until ’
6
3:10” appears, and then tap
DOWN pads will always change the setting by
l-minute increments.) The timer can be set for a
the UP pad until “3:15” is displayed.
maximum of 9 hours and 45 minutes.
3. Press the CLOCK pad and the clock will be set. If
3. To start the timer, press the TIMER pad.
you do not press the CLOCK pad, the clock will
If the TIMER pad is not pressed, the timer will
automatically be set within one minute.
automatically start after a few seconds.
As the timer counts down, a single beep will
indicate when one minute is left. After this beep,
the display will count down in seconds. When the
timer reaches
“:00~’ you will hear three sets of three
short beeps, and then a single beep every 10 seconds
for 10 minutes or until you press any of the
Cloc~imer pads.
To Change or Cancel the Timer Setting
When the timer is counting down, use the UP and DOWN pad to change
the remaining time, or press the TIMER pad to cancel the timer function.
The timer function cannot be
cancelled until “SET TIMER” stops flashing
and “TIMER” appears on the display.
To Display the Time of Day While the Timer Is Operating
Pressing the CLOCK pad while the timer is operating will not interfere
with the timer’s operation; the display will change to show the time of day,
but the timer will continue to count down and will still signal when time
is up. Simply press the TIMER pad again to change the display back to
show the timer function.
(continued next page)
11
—