Gas Range Use and Care & Installation Guide

❑ LEVELING THE RANGE
1. Remove the storage
drawer, broiler drawer or
kick panel.
2. Use a 3/16” open-end or
socket wrench to back out
both rear leveling legs
approximately two turns.
3. Use a 1’%” open-end or
adjustable wrench to back
out the front leveling legs
two turns.
4. Install the oven shelves in
the oven and position the range
where it will be installed.
5. Check for levelness by placing a spirit level or
a cup, partially filled with water, on one of the
oven racks. If using a spirit level, take two
readings—with the level placed diagonally first
in one direction and then the other.
6. Adjust the leveling legs until the range is level.
7. After the range is level, slide the range away
from the wall so that the Anti-Tip device can be
installed.
❑
11 INSTALLING IHEAHII.IIP DEVICE
WARNING:
● Range must be secured with an approved
Anti-Tip device.
s Unless properly installed, the range could
be tipped by you or a child standing, sitting
or leaning on an open door.
. After installing the Anti-Tip device, verify
that it is in place by carefully attempting to
tilt the range forward.
● This range has been designed to meet all
recognized industry tip standards for all
normal conditions.
. The use of this device does not preclude
tipping of the range when not properly
installed.
. If the Anti-Tip device supplied with the
range does not fit this application, use the
universal Anti-Tip device
WB02X7909.
1. Mark the wall where the NGHT EDGE of the
range is to be located. Be sure to allow for the
countertop overhang if you intend to install the
range next to cabinets.
toward the center of the range from the marked
edge of the range.
3. Using the device as a template, mark the
position of the hole for the screw.
4. For wood construction, drill a pilot hole at an
angle of 20 degrees from the horizontal. A nail
or awl maybe used if a drill is not available.
Mount the Anti-Tip device with the screw
provided.
For cement or concrete construction, you
will need a
1/4” x 1%” lag bolt and a 1/2” O.D.
sleeve anchor, which are not provided. Drill
the recommended size hole for the hardware.
Install the sleeve anchor into the drilled hole
and then install the lag bolt through the device.
The bolts must be properly tightened as
recommended for the hardware.
5. Slide the range against the
wall, and check
for proper instillation by grasping the front
edges of the rear surface unit openings and
carefully attempting to tilt the range forward.
WHEN ALL HOOKUPS ARE COMPLETED:
~KE SURE ALL CONTROLS ARE LEFT IN THE
OFF POSITION.
~KE SURE THE FLOW OF COMBUSTION
AND VENTILATION AIR TO THE
MNGE IS
UNOBSTRUCTED.
39