Gas Range Use and Care & Installation Guide

HOW TO CONVERT THE RANGE FOR USE
WITH 1P GAS OR NATURAL GAS (continued)
❑ CONVERT TOP BURNER VALVES
il II
NOTE: Only valves
with these types of
knobs are adjustable.
1. Turn all top burners to LOW.
2. Remove all four knobs.
3. With a small flat blade screwdriver, turn the
valve set screws clockwise to decrease flame
size, counterclockwise to increase flame size.
Adjust until the flame is about the same height
as the top of the burner.
4. Replace knobs.
5. Check for flame outage by opening and
closing the oven door several times. If the flame
goes out, increase the flame size.
❑ ADJUST THE SURFACE BURNER PILOYS
(for models equipped with standing pilots)
b~accessed through the
small hole near the center
of the manifold panel.
3. To adjust, use a blade-type screwdriver with
a shaft diameter of less than 3/16”. Turn pilot
adjustment screw until pilot is 5/16” high. DO
not reduce the flame to less than 5/16” or pilot
outige may occur. A pilot flame burning higher
than recommended may generate soot (carbon
black) on the bottom
of your cooktop.
(A) Yellow flames—
Call for service
(B) Yellow tips on
outer
cones—
Normal for LP gas
(C) %R blue flamee
Normal for natural gas
❑ CHECK QUALITY OF FL~Es
fie combustion quality of burner flames needs
to be determined visually.
If burner flames look like (A), call for service.
Normal burner flames should look like (B) or
(C), depending on the type of gas you use.
With
LP gas, some yellow tipping on outer cones
is normal.