Installation Instructions

1
TOOLS YOU WILL NEED
MATERIALS YOU WILL NEED
31-10985 (01-15 GE)
Installation
30” Electric Cooktop - Radiant
Instructions
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT ³ Save these instructions
for local inspector’s use.
IMPORTANT ³Observe all governing
codes and ordinances.
Note to Installer – Be sure to leave these
instructions with the Consumer.
Note to Consumer – Keep these instructions for
future reference.
Product failure due to improper installation is not
covered under the Warranty.
WARNING ³ This appliance must be
properly grounded.
ATTENTION INSTALLER ³ALL
COOKTOPS MUST BE HARD WIRED (DIRECT
WIRED) INTO AN APPROVED JUNCTION BOX. A
“PLUG AND RECEPTACLE” IS NOT PERMITTED
ON THESE PRODUCTS.
Proper installation is the responsibility of the
installer and product failure due to improper
installation is NOT covered under warranty.
Wire Nuts
Junction Box
Saber Saw
Pencil
Safety Glasses
1/8” Drill Bit & Electric or
Hand Drill
Ruler or Straightedge
Phillips Head
Screwdriver
Excludes Down-Draft Models
If you have questions, call 800.GE.CARES or visit our website at: GEAppliances.com.
In Canada, call 800.561.3344 or visit our website at: GEAppliances.ca.
PARTS INCLUDED
2 Hold Down
Brackets
4 Screws
(WB01X1137)
Foam Tape
WB06K5042
90º or Straight
Squeeze Connector
for 1” Conduit

Summary of content (16 pages)