Installation Guide

17
USE TOP CABINET TEMPLATE FOR
PREPARATION OF TOP CABINET
B3.
• Read the instructions on the TOP CABINET TEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
CAUTION
: Wear safety goggles when drilling
holes in the cabinet bottom.
Wall
Mounting
Plate
Spacing for Toggles More
Than Wall Thickness
Toggle
Bolt
Toggle Wings
To use toggle bolts:
Bolt End
Installation Instructions
You need to drill holes for the top support screws and a
hole large enough for the power cord to fit through.
Place the mounting plate against the wall and insert
the toggle wings into the holes in the wall
to mount the plate.
NOTE: Before tightening toggle bolts and wood screw,
make sure the tabs on the mounting plate touch the
bottom of the cabinet when pushed flush against the
wall and that the plate is properly centered under the
cabinet.
CAUTION
Be careful to avoid pinching
fingers between the back of the mounting plate and
the wall.
Tighten all bolts. Pull the plate away from the wall to
help tighten the bolts.
3
4
1
Remove and save screws that holds blower motor
to microwave oven.
ADAPTING MICROWAVE
BLOWER FOR OUTSIDE BACK
EXHAUST
B4.
Back of Microwave Oven
2
Open the blower door by lifting it up at the back of
the microwave. Remove and save the blower shield
on the back of the microwave by sliding it up.
Remove and save the metal vent fan cover on the
back of the microwave by sliding it up.
4
Rotate blower unit counterclockwise 180°.
Before Rotation After Rotation
Back of
Microwave Oven
Back of
Microwave Oven
3
BEFORE: Fan Blade
Openings Facing Up
End B
End A
Carefully pull out the blower unit. The wires
will extend far enough to allow you to adjust the
blower unit.
Blower Retaining
Screws