Manual

Before You (;all For Service...

Hadianl (ooklop

Save time

and money!

PROBLEM POSSIBLE CAUSE

PAN DETECTION " hnproper cookware being used. Use a flat, metallic pan that is 4.0"

OR SIZING NOT or larger.

WORKING

PROPERLY * Pan is imi_roperly placed. Make sure that the pan is centered on the

corresponding surtace unit.

TEMP LTD APPEARS • Time-Out ti_ature acti\z_ted. Allow the surtace unit(s) to

IN THE DISPLAY cool fin" 1/2 to 1 hour betore using again.

• Cooktop teature activated. The cooktop has a rapid heat-u l) teature

and is designed to do this.

SURFACE UNIT IS

GLOWING HOT

WHEN IT SHOULD

BE ON A LOW

POWER SETTING

SURF'ACE UNIT IS

NOT GLOWING

RF]D

"F" AND A NUMBER

APPEAR IN THE

DISPLAY AND THE

COOKTOP BEEPS

• The surtace units will only be visibly red at power levels 6-H. M power

levels i,-5, the red glow is not visible btlt the StlI't_lce tlnit is working

I)ropett):. After changing a surtilce unit f'l'Oll/ _1higher power level to

a lower power level, the red glow may disappear temporarily in order

to quickly achieve the desired temperature. If the new power setting

is greater than 5, the red glow should real)pear within several minutes.

• You haxe a flmction error code. X,_rite down the "F:- - -" and

touch the _) (CONTROl, I,OCK) pad. Disconnect power to

the cooktop and then reconnect. If an F-code appears again, call

tot set\ice.