Installation instructions 36" Induction Cook top If you have questions, coll 800.GE.CARES or visit our website ab: Noncompliance. in Canada, call 800.961.3344 or visit our website at: Misapplication. BEFORE YOU BEGIN Read these instructions completely and carefully, + IMPORTANT -— save these instructions for local inspector's use. + IMPORTANT — observe al governing codes and ordinances. + Note to Installer Be sure to leave these instructions with the Consumer.
installation Instructions IMPORTANT SAFETY INSTRUCTIONS FOR YOUR SAFETY + For Personal Safety, remove house fuse or open circuit breaker before beginning installation. Failure to do so could result in serious injury or death. Be sure your cook top is installed properly by a qualified installer or service technician. To eliminate the risk of burns or fire due to reaching over heated surface elements, cabinet storage located above the surface units should be avoided.
installation Instructions PER-INSTALLATION CHECKLIST BEFORE YOU BEGIN A WARNING = the electrical power to the cook top supply line must be shut off while connections are being made. Failure to do so could result in serious injury or death, Tal When preparing cook top opening, make sure the inside of the cabinet and the cook top do not interfere with each other. {See section on preparing the opening} [el Remove packaging materials and literature pucker from the cook top before beginning installation.
installation Instructions PREPARING THE OPENING 1] The following MINIMUM clearance dimensions must be maintained. if 0 30" concealer between the cooking surface and overhead combustible materials or metal cabinets cannot be maintained, a minim urn clearance of 24" is required and the underside of the cabinets above the cook top must be protected with not less than 1/4" insulating billboard covered with sheet metal not less than 0.0122" thick. [3] VERTICAL CLEARANCES {Cont.
Installation Instructions INSTALLING THE COOK TOP [1] PROTECT SURFACE OF COOK TOP Place a towel or tablecloth onto the counter top. Lay the cook top upside down onto the protected surface. HOD ra Bottom Cloth under Cook top [2] INSTALL BAFFLE Secure the baffle to the cook top with screws. NOTE: Do not install the baffle when the cook top is installed over a single oven. Fae. Hux Hood Screws [3] ATTACH FOAM TAPE Apply the foam tape around the outer edge of the glass. Do not overlap the foam tape.
installation Instructions INSTALLING THE COOK TOP (CONT. [5] INSERT COOK TOP INTO CUTOUT Insert the cook top centered into the cutout opening. Mike sure the front edge of the counter top is parallel to the cook top. Make final check tho all required clearances are met, Hilda Down Bracket Attach Hold Down Brackets to cabinet.
Installation Instructions ELECTRICAL CONNECTIONS NEW CONSTRUCTION AND BRANCH CIRCUIT CONNECTION A WARNING: Improper connection of aluminum house wiring to copper leads can result in an electrical hazard or fire. Use only connectors designed for joining copper to aluminum and follow the manufacturer's recommended procedure closely. when making the wire connections, use the entire length of conduit provided, The conduit must not be shortened {unless required by local codes) The conduit length is 4 ft.
installation Instructions CHECKLISTS [1] PER-TEST CHECKLIST [a] Remove all protective film, if present, and any stickers. [EB] Check to be sure that all wiring is secure and not pinched or in contact with moving ports. [£7 check level of appliance. [0] Check tho the cook top is properly grounded. [2] OPERATION CHECKLIST [a] remove all items from the top of the cook top surface. [Ee] Turn on the power to the cook top. {Refer to your Owner's Manual) Verify that all surface burners operate properly.
Instrucciones de instalación Estufa de inducción de 36" Si tiene alguna pregunta, lame o 800.GE.CARES ¢ visite nuestro sitio Web en: GEAppliances.com ANTES DE COMENZAR Lea estas instrucciones por completo y con detenimiento. + IMPORTANTE cuadre estas instrucciones para el uso de inspectores locales. + IMPORTANTE — Cumpla con todos los códigos vy ordenanzas vigentes.
instrucciones de inflacionista INSTRUCCIONES DE SEGURIDAD IMPORTANTES PARA SU SEGURIDAD = Pura seguridad personal, quite los fusibles o desconecte el cortacircuitos antes de comenzar la inflacionista. No hacerlo puede provocar la muerte o una lesión personal grave, Verifique que un instalador o un técnico calificados instalen su estufa correctamente.
instrucciones de inflacionista LISTA DE CONTROL PRE-INSTALACIÓN ANTES DE COMENZAR A ADVERTENCIA ~ 10 energía eléctrica de lo lineo de abastecimiento de la estufa debe estar desconectada mientras se realizo las conexiones. No hacerlo puede provocar la muerte © una lesión personal groe, Cuando realice uno abertura para lo estufa, verifique que lo parte interna del gabinete v lu estufa ne interfieran entre si. Ver sección sobre la preparación de la abertura.
instrucciones de inflacionista COMO PREPARAR LA ABERTURA 1] Deben mantenerse los siguientes dimensiones MÍNIMAS de espacio libre. Si no se puede mantener un espacio de 30” entre lo superficie de cocción y el material combustible superior o gabinetes de metal, se requiere un espacio libre mínimo de 24", y el lado inferior de los gabinetes por encima de lo estufa debe protegerse con cartón aislante no menor a 1/4" cubierto con planchas metílicos con un grosor no menor 0.
Instrucciones de instalación COMO INSTALAR EL ESTUFA [1] PROTEJA LA SUPERFICIE DE LA ESTUFA Coligue una tesalia o mantel sobre lo mesado. Deposite lo estufa of revés sobre la superficie protegida. paste inferior del estafo Paro bina el estufo [2] INSTALE EL REFLECTOR Sujete el reflector a lu estufa con los tornillos, NOTA: No instale el reflector cuando la estufa estad instalado sobre un horno segallo. [3] COLOQUE CINTA DE ESPUMA Aplegue lu cinta de espuman alrededor de los extremos exteriores del vidrio.
instrucciones de inflacionista COMO INSTALAR EL ESTUFA (Con) 5] INSERTE LA SUPERFICIE DE COCCIÓN EN EL ENCASTRE Inserte lo estufa centrada en el drene cortada. Aseglares de que el borde frontal del mostrador esté paralelo con respecto a lo estufo, Asegúrese de verificar al final que todos los espacios especificados hayan sido respetados. Adhiera los Soportes al gabinete.
Instrucciones de instalación CONEXIONES ELÉCTRICAS CONEXIÓN DE CONSTRUCCIÓN NUEVA ¥ DE CIRCUITO DERIVADO A ADVERTENCIA: una concesivo inadecuada de cableado doméstico de aluminio con cables de cobre puede generar un peligro eléctrico o un incendio. Solé use conectores diseñados para unir cobre con aluminio y siga al pie de la letra el procedimiento recomendado por el fabricante.
instrucciones de inflacionista LISTAS DE CONTROL [1] LISTA DE CONTROL PREVIA A LA PRUEBA [a] Quite toda la película protectora, si la hubiera, y todos los autodestructivo. [8] verifique que todo el cableando esté seguro y que no haya sufrido pellizcos o esté en contacto con partes en movimiento.