User guide Telephone radio alarm clock PETITE TRAC
SETTING UP FIT A 9 VOLT PP3 BATTERY Why? Because if you have a power cut or disconnect your Petite Trac for any reason you won't have to re-set the clock. - Remove the battery cover underneath the telephone. - Fit the battery, ensuring that the correct polarity is observed. - Replace the battery cover. NOTE: Battery back-up is not designed to support the clock operation for lengthy periods in the absence of mains supply. It is recommended that the battery be changed every 6 months or earlier if necessary.
SETTING UP CLOCK TIME SETTING The correct time should be set as follows: - Press and hold down Time button. - Whilst holding down the Time button, press Hour and then Minute buttons as necessary to display the correct time. Note: that the clock is a 12 hour clock; in the case of PM, an indicator will show to the top left of the clock display. RINGER SETTING A switch (Ringer) located on the rear of the base unit allows the ringer to be switched On or Off.
USING THE TELEPHONE ANSWERING INCOMING CALLS When an incoming call is received, the telephone rings (if the Ringer switch is On) and/or the lamp flashes. To answer the call lift the handset and speak. MAKING A CALL Lift the handset, await the dial tone and dial required number. On completion of the call, carefully replace the handset in the cradle.
USING THE TELEPHONE MUTE BUTTON - If you wish to speak privately to someone else in the room – without your caller overhearing – press and hold the MUTE button. Your caller may still be heard during the MUTE operation. - To resume normal conversation , release the MUTE button. For product support and help visit our website at www.geemarc.
RADIO ALARM CLOCK OPERATE The radio has 2 wavebands: Medium Wave (AM) and VHF (FM). A built in aerial is incorporated for Medium Wave reception. For VHF reception, the thin lead should be unwound and fully extended. Adjust the position of the lead for best results. On this unit the Volume control and Tuning control are located at the right hand side. The buttons for operating radio (AM/FM and Radio/Off/Auto) are located at the left hand side.
RADIO ALARM CLOCK OPERATE WAKE UP TO MUSIC Set the alarm time and select your desired radio station, adjust the volume control to your preferred listening level and proceed as follows: - Slide the Radio / Off / Auto switch to the Auto position (if the radio was playing this action will switch it off). The alarm indicator at the bottom left hand of the clock display will illuminate. - To switch the radio off after waking up press the Sleep button followed by the Snooze button.
RADIO ALARM CLOCK OPERATE SNOOZE OPERATION When the radio is switched on by the alarm, pressing the Snooze button will silence the radio for approximately 9 minutes. The alarm will then switch the radio or buzzer on again. SLEEP TO MUSIC The radio can be set to play and switch off automatically for a length of between 1 minute and 1 hour 59 minutes. - The radio Volume have to be switched on. - Set the Radio / Off / Auto switch to the Off position.
RADIO ALARM CLOCK OPERATE COMBINATION OF SLEEP AND WAKE TO MUSIC OPERATION The radio can be adjusted to automatically switch off in the 'sleep to music' operation and to switch on automatically again at the preset alarm time. - Set the radio as per WAKE UP TO MUSIC operation. - Slide the Radio / Off / Auto switch to the Auto position. - Press and hold down the Sleep button. For a length of time over 59 minutes press the Hour button and release.
GUARANTEE From the moment your Geemarc product is purchased, Geemarc guarantee it for the period of one year. During this time, all repairs or replacements (at our option) are free of charge.Should you experience a problem then contact our helpline or visit our website at www.geemarc.com.The guarantee does not cover accidents, negligence or breakages to any parts. The product must not be tampered with or taken apart by anyone who is not an authorised Geemarc representative.