8340A Operating Manual
Introduction Congratulations and a thank you for the purchase of this Genelec Smart Active Monitor (SAM) system. This manual addresses the stand-alone setup and use of the 8340A SAM monitor. These monitors can also be set up and used with the Genelec Loudspeaker Manager GLM™ and the proprietary Genelec monitor control network and software, offering much more versatile acoustic settings and features. Use with the GLM™ is described in the GLM™ System Operating Manual.
DIP SWITCHES FOR STAND-ALONE USE ROTARY LEVEL CONTROL POWER SWITCH ON OFF ON OFF -4 -6 -2 0 SMART ACTIVE MONITOR 4k 20k LED DISABLE ISS A DIGITAL B -10 dB -20 dB STORED LEVEL -2 -4 -2 -4 +2 -4 -4 (dB) 800 BASS TILT TREBLE TILT TREBLE TILT BASS TILT DESKTOP BASS ROLL-OFF 160 BASS ROLL-OFF 20 ALL OFF DESKTOP 160 Hz +2 0 -2 -4 -6 dB dBu +2 +6 +4 SENSITIVITY IN dBu FOR 100 dB SPL (1 m) RESET TO FACTORY SETTINGS: PUSH BUTTON FOR 10 SEC Frequency (Hz) AUDIO SIGNAL CONNECTORS: MAINS INPU
>0 ,7 m h ACOUSTIC AXIS 8340A: h=240 mm (9 7/16 in) Figure 3. The location of the acoustic axis is on the centerline of the monitor at the given height “h”. m Min 5 c Max 60 cm Avo > 60 cid m Figure 5. Recommended distances from a single wall to the front baffle of free-standing monitors. Correct (green) and not recommended (red).
Colour Indication Solid greed Normal state, normal operation Blinking green GLM is adjusting the monitor Green blink every 10 sec. Monitor is an ISS power saving sleep state Red blink Power amplifier overload protection is active (audio is modified because of protection) Solid red Monitor is muted Yellow Monitor is not in the active (playing) group Yellow blinking Overheat protection is active (audio is modified because of protection) Table 2.
Genelec Oy 8340A 1 April 2016 Genelec Oy 8340 horizontal off axis response level (dBr) vs freq (Hz) 10 Mar 16 90 100 85 95 90 80 d B r DESKTOP LF 85 A 80 90 0° 15° 85 30° 80 BASS TILT 45° 90 75 85 70 60° 80 65 TREBLE TILT BASS ROLL-OFF d B r 60 55 A 20 50 100 200 500 1k 2k 5k 20k 10k 50 20 50 100 200 500 1k 5k 2k Figure 7.
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna.
AMPLIFIER SECTION 8340A Bass amplifier short term output power Treble amplifier short term output power (Long term output power is limited by driver protection circuitry) 150 W 150 W Amplifier system THD at nominal output <0.
